Hi,
We are developing an application that requires synchronization between two or more nRF9160-based devices. We have the following requirements and constraints:
Required...
I'm using the prebuilt Aliro stack (libaliro.a, nRF52840), when a session fails inside the library we have no way to get the resulting AliroErrorCode. The stack entry points...
Hello
We are using nRF5340 as our EVK with a 12 antenna array plate(4x4 with center 4 ones not being there). Our beacon uses nRF52833.
We used Nordic's sample codes- ...
While configuring a scene, the blind device is not visible in the scene settings screen, so it is not possible to set or save the blind position as part of the scene.
Steps...
Hi all — I'm developing a custom nRF5340 development board (Raytac MDBT53-1M) and would value the community's honest read on whether it's worth producing.
The goal is...
Hi there
I tried to observe the message when DTM are working.
So I modify the example direct_test_mode to display on monitor.
But after modified , it comes out the error...
The nRF5 SDK references a field ble_adv_legacy_enabled in the ble_adv_config_modes_t structure (see http://infocenter.nordicsemi.com/index.jsp?topic=%2Fcom.nordic.infocenter...
nrf52832.
SDK14.2
Segger ES V3.34a
I am using sd_ble_gatts_value_get, in C file named ble_cus.c to retrieve the 'value' of a characteristic as written to by the...
Recently i am developing an application based on UART on nRF51822 platfrom, where an application receives the data through UART. During development, i went through nRF UART...
Hi,
We're using SR3 v1.1 for several BLE R/C.
Early this month, we received information of Engineering C Errata.
It suggests that we upgrade to SR3 v1.2 for fixing some...
Hi
I am writing a bootloader and am trying to get the start locations of the different memory segments e.g. the FLASH start segment from the flash_placement file.
On a...
Hello, I am developing a system where I have a app and a Rigado BMD-300 Module. I am using, for experiment, the nRF Connect App and in program, I use SDK 14.2 and s132 softdevice...
Hi to everyone,
sorry if this question will result stupid, but I'm really new on programming Nordic microcontrollers.
I'm trying to develop a simple ble application for...
1. Did secure BLE DFU first time for hrs app, BL jump to hrs app
2. Did secure BLE DFU second time for hts app, BL jump to hts app
3. Did nrfjprog HID keyboard app and...
Hello,
I am using NRF52840 board and SDK 14.1, Softdevice 5.0.0-2.
I am testing other devices on my board. However, it seems to work normally until 2, but the connection...
Hi,
I just try the new mesh SDK V2.0.0. And I found that there is an error if I compile the "examples\light_switch\proxy_client" more than one time.
The error is here...
Hi,
I have successfully flashed nRF24LU1+ via ISP. Right now, I am validating using USB to download firmware for future production. Here is the issue.
Our project has...
