I am trying to get a WiFi project working using the nRF52840DK and nRF7002EK . I use a 3.3V power source that is supplying power to both nRF's in parallel. For the nRF7002EK...
Hi,
I'm developing firmware for the nRF52840 DK using nRF Connect SDK v2.9.2 , and I’m running into a problem that didn’t occur in v2.8.0 .
My project uses Zephyr and...
I am receiving an error when connecting to a custom board by running nrfjprog --reset, any similarly with any other commands that require connection.
I am connecting through...
We have previously used nRF52840 and for the latest iteration of our board design we are updating to use nRF54L15.
We are aware that for nRF52840 we could map any pin to...
Hi,
I faced with an initialization issue of combination two features: MCUMGR and UART_ASYNC_API. I get a crash right after the FW starts. It looks like the SW configuration...
I checked the nrf52832 manual and found that both XC1 and CX2 are analog input pins for the 32Mhz clock pin configuration. The reference design for both uses 32Mhz crystals...
Hello, I need to configure and compile a sample to send an audio stream (mp3) to the I2S interface.
I tried to put together some configuration from other samples but no...
A LOT of great information is presented by the engineers. Is it possible to post videos of the presentations?
Apple does this for the WWDC sessions. I find myself watching...
Hello Everyone,
i ahve been working on NRF51 series for past two months but suddenly i came to know about NRF52 series the apckage is ame and proce also not varying much...
Hello,
Now I am using nrf51822 with PCA10004 EK board. And the custom board we are using is BL600-SA module. As BL600 can be used with nrf SDK and softdevice, Can I use...
I have a Bluetooth LE dongle and I have also a BLE device that I want to communicate with.
On the BLE device there are a several services like Cycle Power (0x1818) and Device...
I'm using the Ulink-ME tool in order to program/debug my custom board based on the nRF51822 device. The problem I have is that sometimes the flashing procedure is working...
Hi,
I do some function base on the ble_app_uart peoject and using the S130.Now I want the device disconnect the connection once it receives the disconnection command from...
We are looking into upgrading to the newer nrf52 SoCs from the current nrf51s. From the looks of it, the SoftDevice S132 is still in the alpha stage of design and validation...
Hello,
I am using SDK 9.0 and softdevice 8.0 and testing on Evaluation board.
I referred the i2c example driver suggested by Torbjorn in this link
I wrote a simple...
Hi,
Are there any plans to release the nRF51822 sniffer source ? I can only see ihex binaries in search results. I am developing some dev boards using nRF51822 xxAC and...
Hi,
I've read through several posts on this excellent forum for nRF51 on audio.
But, I have the new nRF52 Dev Kit and would like to use an analog signal from a microphone...
Hi Gentlemen,
i want to pair my mobile(central) with peripheral device by entering passkey
note: No input or display on peripheral device
suggest the method with sample...
I use 51822 HW TWI to become master.when i send the first byte(Address+write or read bit) to sensor,the event TWI-ERROR is set.Who can tell me, what is the cause of this event...
hi:
now.i have a development board(nrfgo motherboard).there is a debug port on the board.i think it can be debugged on the keil.if it can.what driver or others i need.thank...
