hello,
I use nrf51822 + S130 + SDK12.2 in my product, nrf51822 work at central + peripheral mode，and i use nrf_duf_flash module for my dfu funtion.
The problem is, i...
I want to communicate Central and peripheral devices with KeyPass. Also I want to generate keypass in Peripheral device. But keypass should to include symbols, low/upper case...
I am using SEGGER Studio on MacOSx.
When use the latest mesh SDK, I can run the light_control example and see the debug log in the Debug Terminal of SEGGER Studio.
However...
Hello,
I'm trying to setup a nRF Cloud Bluetooth gateway using my PC (with openSuse 42.2 64bits and rRF Connect v2.1.0 + nRF Cloud Gateway v0.9.7) and a nRF52 DK and I...
Hello: I am using an NRF51 dongle. Date on the device sticker on the back is 2015.38. Also using nrf51_ble_driver_linux_0.5.0.
I can see/connect to the device I am trying...
Hey,
I just want to know if anybody sucessfully connected HDMI CEC (One-Wire bus) with the nRF52832.
I would be very grateful if anybody could share the library or give...
Hello!
I am having a problem using any internal flash writing libraries. If I set the REG0 voltage to 2.7V, the controller stops erasing the memory.
Moreover, I cant erase...
Hi,
I have seen that the pin for nRESET is selected on the NRF_UICR->PSELRESET register. I know that it cannot be modified from 0.21 on the 52832.
Can it be modified on...
Hi guys,
I am trying to figure out how to send the sensed data (temperature value) from the LPN node to the server node in the BLE mesh network. I have already found this...
I am using the nrf5340PDK and i am trying to have P1.04 trigger an interrupt on a high to low transition.
attached is my overlay file and my main.c to initialize the GPIO...
I made a code based on ble_app_uart_c which connects to a peripheral and once connected it can write or read data.
The code is supporting BLE4 (1M) and BLE5 (Long Range...
Dear Concern,
we have tried to configure the accelerometer LSM6DSO module through SPI interface using NRF52xx DK board. External Module was not configured properly...
Since the Online Power Profiler only supports 1M PHY, does a static power profile for coded PHY exist that shows the current levels for the full advertising length? I'd like...
hi
nRF5 SDK for Thread and Zigbee v4.1.0
need to build a simple sensor with analog input .
Referring to the simple sensor (binary input ), I did make a ZED simple binary...
i made a mesh network using cli ftd uart example and transfer data using udp portal
there comes a need for me to indicate reset command through switch and send reset command...
I have 2 devices connected, working in notification mode. Using the nRF Sniffer for Bluetooth LE I was able to check all the messages that are exchanged. When in close proximity...
Hi, We have chosen to put our project and "custom board" outside of the NCS-directory. And since the newer revisions of SES, the "Open nRF Connect SDK Project" dialog window...
Hi,
On the P eripheral , after establishing a connection with the Central , start the timer to send data to the Central (the timer interval is set to 500ms and stop after...
