Hi,
Has anyone converted the Adafruit graphics library for Arduino, Adafruit_GFX.h, to be compatible with the nRF51?
Could you please advise on how to convert this Arduino...
Hi all,
I have a few questions:
How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc...
The datasheet has "typical...
Hi all !
I'm trying to evaluate the throughput i can have between a Motorola 4G and the nrf51. The nRF51 is the peripheral and the phone is acting as a central.
To do...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
Hello, Nordic Team, I'm embedded designer from Russia, discovered your amazing wireless MCU NRF52832. I looked through your SDK and peripheral drivers, and unfortunately found...
Thanks Stefan. The zip file making and updating steps work perfectly for me, if I follow your steps and make it from your stock pre-built "dfu_test_app_hrm_s132.hex". My question...
SDK: 15.3.0 SoftDevice: S132 Device: EYSHJNZWZ (nRF52832)
The following vulnerability "CVE-2020-10135" has been reported by the Bluetooth SIG. Will this device be affected...
Hello
I am using SDK v17 and sending the value of acceleration sensor to the app.
I want to use this value to process some action in the app. For example, if the transmitted...
Hello Nordic Community,
I've stumble upon an issue with a characteristic configured to not require authorization but still does on certain occasions.
Consider a service...
I'm new to the nrf5 GPIO functionality and having a little difficulty getting started. Upon having called `nrfx_gpiote_in_init`, my app reports a fatal error and the device...
I wanted to know the function or functions and the steps to associate an interrupt with an event.
I will be getting a single Pulse(Low To High) which will be my interrupt...
Hi,
I am using the nRF52840 dongle and am seeing problems when I try to use port 1 pins.
For instance, if I try to write to pin P1.01,
I see this error
I seem...
Hello Nordic Engineers:
SDK Verssion: nRF5_SDK_15.2.0_9412b96
IDE: Segger Embedded Studio
I use 1 Central and 5 Peripherals to build the network，they all can build...
Hi..
I want to update the firmware over OTA. For the first time I have downloaded ble_secure_bootloader and softdevice, then I flashed the application file by scanning the...
Hello,
I am trying to develop and application that will be able to scan for some time for beacons in the area around it. From all found beacons and using the RSSI of each...
Hello,
I have implemented a file system on the external flash, following the example: " USB MSC Example ", SDK16, nRF52840. The objective was to implement an audio recorder...
Hello,
We have a released product that is using the nrf52832 (rated at 85C). We have used this MCU and we have don't have issues so far.
Recently, it came a small...
Hi Dev Team,
I have been trying to send data across from my nRF9160DK board to an external sensor via RS-485. For this, I have a TTL_RS485 converter in between.
To start...
I am trying to buy an NB-IoT SIM card in the UK as the LTE-M SIM included with my Thingy:91 does not work here. I know that Vodafone supposedly run the NB-IoT network here...
Hello,
I have added DFU to our project. In general it works, at least parts of it.
Assume I receive often/always NRF_DFU_EVT_DFU_FAILED, how do I find out, what is the...
