Hi all,
I am using ble open mesh with pca10028 boards ble mesh is working fine.
I am developing a application that has to blink led in mesh( without any delay between...
I'm still on stack 8.0.0 so it might have been fixed since. I have noticed that if the other side de-asserts CTS the Nordic code will leave the TX asserted in a Break condition...
Hello,
I'd like to ask what is the data rate when using BLE OpenMesh network and how much it depends on network architecture.
I'm considering using it in a network consisting...
Hello Nordic Community,
I need to know how to import my PCB design from Eagle to CST Studio to simulate it and I need to know if the simulation step will be useful to enhance...
Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
I have a long PDU which I need to send fragmented by indications.
So in a while loop I populate a ble_gatts_hvx_params_t hvx_params struct and call
error_code = sd_ble_gatts_hvx...
i am following this tutorial to change a Keil 5 project (sdk 12.1.0 S132 )into ses project.
https://infocenter.nordicsemi.com/index.jsp?topic=%2Fug_gsg_ses%2FUG%2Fgsg%2Fimport_ses...
I have a nRF5340PDK, Now I want to know the lowest power consumption of this chip in different condition, such as adv, connect, sleep. But I am not sure how to config the...
Hi.
I am testing sleep mode using nrf_pwr_mgmt_run().
When nrf_pwr_mgmt_run() is called, it is changed to sleep mode, but it wake-up up immediately and it is changed to...
Hi,
We are getting a request from our customer on supporting on NB-IoT PoC test cases as below.
Can you please let us know how we can simulate or execute the same?
...
I have written two methods to read and write value from fds.I get FDS_EVT_WRITE call back with p_fds_evt->result=!= FDS_SUCCESS
but when i try to read it after that it gives...
Hello,
I use the method, armgcc.
The commends "make flash_softdevice" and "make flash" echo the below. It seems OK. But I cannot see the app "/nRF5_SDK_12.3.0_d7731ad...
Hi,
I'm having a bit of a problem with using friend nodes in mesh networks. I have connected a friend for 2 nodes:
1, But I do not understand the real mechanism of the...
Hi,
I am trying to receive data using USB Custom HID.
Data reception is normal using "app_usbd_hid_generic_out_report_get", but the data size is always 64 bytes.
Is...
Greetings,
We are using nrf-sdk v1.3.0.
We would like to monitor an adc channel using either limit event monitoring or maybe LPCOMP.
I was able to find "low level" documentation...
i am using ble_app_gatts example as beacon observer ,till 10 sec after powering up device i need connectable advertise after that period ,as i switch the advertising from...
Can you do successive updates to a Notify Characteristic using sd_ble_gatts_hvs() during the same connection interval without losing data.
The question comes down to, does...
