Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
I go into MCUBoot mode and I get: MCUboot DFU failed. Error occured when program. Errorcode: CouldNotOpenDevice (0x4) Lowlevel error: Unknown value (ffffff8e) When trying...
Hi all,
I'm evaluating design for a bluetooth + GPS + NB-IoT ultra-low power device
I see the only possibility to get a such module is to design it (I didn't found anything...
Hello,
I'm trying to auto-build my application through Github actions however I'm running into this problem
When I try to run this locally it works perfectly fine however...
Dear All, I am trying to measure the current consumption for an application I am developing on the nRF52833 DK. The code that I am running is the following: Based on the product...
Dear All, I would like to configure a device to go to the System ON, no RAM retention, wake on RTC (running from LFRC clock) Sleep mode, in order to be able to use the RTC...
Hello,
we are using nrf5 SDK version is 17.0.2 and nrf52840.
Our product uses nrf52840 and its USB capabilities being configured as a composite device (HID keyboard +...
Hi,
i would like to know which software i have to download and install, so that i can program a really basic function like pressing the button and turning on and off an...
Hi,
I saw a Linkedin post by Zephyr where they mentioned some Vscode extensions for devicetree and kconfig:
https://marketplace.visualstudio.com/items?itemName=trond...
Hi,
unfortunatally i could not add a new LTE device. I was able to activate my SIM card but not able to finally add the device to my account.
The error code is: There...
I am currently following the tutorial for creating custom services ( https://github.com/NordicPlayground/nRF5x-custom-ble-service-tutorial ). The only differences to this...
Hello Nordic,
I'm working with NRF52840 (with SDK 16 and softdevice s140 7.0.1) in my project. I need to work with another chip through SPI. This chip is the master and...
Hello,
I have one more questions while doing test with SAADC, UART.
When I was tested the SAADC pin connect with ground, the negative value occurs.
So, I changed the...
Hello,
i've built a basic Thread network with two nRF52840 Nodes running the CLI example and a RasPi with a nRF52840 RCP as BorderRouter.
My Question is:
Whats the...
Hi.
Hope you are well.
I want to send data from nRF51822 to nRF24L01+. I used the esb library to configure the nRF51 and I just change the settings as I want ( some settings...
