After ping through link local address ,i am not getting any Router solicitation messages,neighbor solicitation messages and neighbor advertisement messages while i am capturing...
Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
Hi Devzone:
It's really hard to piece together all the informations so I guess I will seek help here.
I need help choosing the location of one page flash storage for my...
Hi there, Until todayI had no problem programming/controlling my nrf52832 on my custom board. Suddenly Im getting segmentation fault whenever I try to communicate with the...
I am developing an nRF52832 application requiring two separate quadrature encoders interfaces. The included nrfx QDEC driver would work just fine and it would save me a lot...
I have the following statements throughout my code.
printk("Temperature(BMP280): %3.2f %s\r\n",tempFloat,tempUnitsCentigrade?"C":"F");
I would like the format %3.2f...
Hello, I am using the nrf52840 board and SDK(sdk_v15.3.0 and formesh_v3.20).
I have tried to transfer the vendor model status message to the client from the server.
Following...
My nRF 9160 DK is being detect by my computer. And my computer detects that the J-Link driver is connect. But the nRF 52840 is not appearing in file explorer. I'm not sure...
Hey guys,
I have a timer like this:
While this first timer (nrf_drv_timer) is running, I need a second timer whose interval I have to be able to change constantly. ...
Hi
when I try to use printf in the secure wold my nRF9160 resets. I assume that something needs to be configured differently but I don't know what.
The skeleton of my...
I am working with the light switch example and am having some issues surrounding node configuration, namely getting the composition data.
Setup: 1 client/provisioner (both...
I got the dev board all set up and working - managed to program a few examples flashing LEDs etc…. So then I wanted to do a BLE peripheral beacon example and it told me to...
I'm looking at designing my own Bluetooth Receiver essentially. Playing music from my phone to a Bluetooth receiver, to output via AUX.
I was looking at the range of MCU...
Hi,
For my all DFU i follow the steps on the Getting started guide , just in the Performing DFU step i use the nrfutil tool for the over USB.
First i tried with the DFU...
Hi team,
Similar to how we have recommendations to use certain pins for low drive, low frequency on the nRF52 series, do we have those recommendations available for the...
