But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Hi,
I'm using direct advertising in order to connect to mobile devices which were already connected to my nrf device. After the first connection, I save the mobile address...
Could it possible to reduce INIT and ADVERISE times ?
What is normal startup time for nrf52832 init peripheral for advertising?
What is the minimum possible advertising...
In the OPS register description, as well as in the files modules/hal/nordic/nrfx/mdk/nrf5340_application.h and nrf5340_network.h the HFCLKAUDIOALWAYSRUN register is incorrectly...
Hi Guys,
I'm looking for some information on how to get data from the secure side to the non-secure side of the firmware. We are building an NB-IoT GPS tracker which is...
Hi,
Is it possible to change the security option of characteristic read or write?
For example , we initial the characteristic as JUST_WORK? Then change it to SEC_OPEN...
I have adapted the " nrf52-mpu-easydma-using-timers-and-drivers " project from Github that I saw referenced in another post and have successfully modified it to work with...
Hi, We are using the heart rate example for developing our firmware, where we plan to send data out every 15 mins. But when we try to increase the advertisement interval beyond...
Hello Nordic Team,
Currently i'm trying to join my custom HID (a joystick) with the ble_app_hrs_rscs_relay example (SDK 16) for a personal project which consist in: a nrf52832...
Dear Nordic,
I am trying to create a simple interface between my PC with Windows and using PyUSB (since it is a simple wrapper, using libUSB as backend) and the nRF52840...
Hello,
We have an old working product which is developed in nRF5 SDK v11.0.0. We want to add nfc type 4 tag part in our product.
In SDK 11 there is only support for nfc...
I am looking to understand the state of a pin after calling nrfx_saadc_channel_uninit(channel);
Does it simply return to the last configuration state of the GPIO or something...
Hello, I am using a nRF51822 chip to communicate with a sensor. The sensor continuously outputs its reading via UART every couple of seconds. This is what I am currently doing...
Hi, I'm trying to migrate from the nRF9160 DK to our own board, and I'm having some trouble getting the west build system to play nicely. I've essentially started with the...
Hello everyone.
I have been working on a project that involves DSP and BLE on nRF52832.
The firmware needs to sample an accelerometer signal every 1ms with high accuracy...
