Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi,
I am adapting the uart example to send mensages between central and peripheral using JSON. In this moment I can send central <------>peripheral...
I have a problem...
HI I'm developing Mesh network with SDK for mesh 1.0.1.0
I just started with own provisioner code bud a really need some debug print while programme running.
I tried a...
i have created whitelists for filtering connection its working fine now, but when i restart my firmware the stored whitlists data become cleared so i need to bond each time...
Hi All!
I use "examples\peripheral\usbd\" example Project as reference to implement my own HID protocol.
I use only EP1 in/out 64 bytes both.
faced with a question,...
Is it possible for a peripheral device to start a Bluetooth Low energy advertisement and then read the RSSI value in the advertisement packet that it sent once a connection...
Hello,
I have some trouble to use fstorage function with dfu function,
please help to let me know the solution in order to solve the following issues,
thankful for...
Hi,
I'm getting back "01 10 06" when attempting to send 0x01 Start DFU to the DFU Control Point from my gateway which is a Pi3 running Noble. Notifications are enabled....
Hello, i've read in the infocenter that there is/will be a new nRF52840-PDK Hardware (v0.11.x). Is it already available? If yes, who distributes it? If no, when will it be...
nRF52832 SDK 14.2
Hi.
I would like to know how I can run a function in the background? In my case, I want to process a queue in the background. Here is the scneario: ...
Hi all,
after call inside the BLE_GAP_EVT_LESC_DHKEY_REQUEST I got error 8, what can cause it? a CONNECTION_SUPERVISED_TIMEOUT?
device nRF52, SDK13
Thanks
Board: custom board; Mesh SDK: V1.0.0; Softdevice: S132_5.0.0; IDE: SEGGER Embedded; BLE: nrf52832
When I test the example “Interactive PyACI”, I need one node(A) send message...
I'm trying to connect with SPI interface. I've some little problems to understand about how technically do it,
I found this code on the web:
Just to understand how...
