GOAL: To send one 20-byte data packet from an Android Galaxy S5 to nrf51822 and send three 20-byte packets from the nrf51822 to the S5 in a single connection interval of 10...
Hello, I have looked into the compatibility matrix and I couldn't find any clear answer about if the NRF Beacon Kit is compatible or not with the S130. Does anyone tried to...
hi:
now.i have a development board(nrfgo motherboard).there is a debug port on the board.i think it can be debugged on the keil.if it can.what driver or others i need.thank...
This is what I got after upgrading my nRF51 dongle firmware.
It always times out.
I didn't somehow got one of my J-Link Lite upgraded, but couldn't repeat the process...
Hi all,
Good day.
Could you please recommend an Android or IOS APP which can connect 8 or more BLE peripherals at the same time.
Thanks & Regards
Jenson
I know that suggested debugger for nRF51xxx is J-Link or openOCD with CMSIS-DAP, but I would like to use BDI3000 debugger, which does support SWD interface and Cortex-M0 processors...
I'm using FDS together with Flash manager, and checked if everything goes alright in flash.
As per doc, I set FLASH_MANAGER_RECOVERY_PAGE_OFFSET_PAGES to FDS_PHY_PAGES....
Hi, I just try to start with the spi master example (nrf5sdk/examples/peripheral/spi) on mus PCA10040 board. I'm able to compile&flash it. It seems to be running (LED1 is...
Hi ,
I working on the getting started assistant setup but got failure when verify the GNU ARM embedded setup , see the following log :
11:32:05.867
c:\gnuarmemb\bin...
Hi,
Just want to ask what will be the effect if I will use an external oscillator (32.768kHz) with a CL nearly at max specification, let's say 12pF.
Thanks.
Hi,
Can we send a message from a Provisioner to a Unicast address in a mesh network?
I'm using nrf52832 and can send orreceive message between nodes in the mesh but I...
Using 4-bit SPI mode on the Display Controller side: SCL,MOSI,MISO ... and DCX (by which the controller distinguishes between command bytes and data bytes). There's no obvious...
Hi everyone,
Im Nicolas, from Colombia. I want to develop an IoT product, using nRF9160, but don't want to use the DK (is too big for my application). I've been reading...
HI,
I got the following log in my multiprotocol application:
SOFTDEVICE ASSERTION FAILED AT 0x00025b94
Since this address locates at softdevice, I can not know what...
Hi, i want to connect nRF52 Thingy with nRF6707 power profile kit to measure the current acquire by thingy.
How to connect the thingy to power profile kit
And also i...
I had updated Thingy:91 nRF9160 firmware to 1.1.1 using nRF Desktop Programmer. I used the "Cellular Modem" button and attached the new file mfw_nrf9160_1.1.1.zip
However...
Hi
We are developing by connecting nRF52832 to SMT32f303cb's SPI interface.
SMT32f303cb operates as an SPI Master.
If the clock frequency of SPI Master is changed to...
