Hi all,
I am new to Nordic semiconductor but I could be interessed by nRF9E5. To check if it could fit my requierement, I would like to know if it possible to configure...
Hi,
I am using ADC without external reference and no analog input in order to measure the battery level with a timer (code at the end).
I am also reading several ports...
Hi,
I'm programming the nRF51822 and save some user data into the FLASH by using pstorage_update . It works fine if I set system off mode, and wake it up. I can read back...
Hi,
I have been using nRF51822 with my Android app using Android's Bluetooth Low-Energy APIs.
In order to get more details, I am currently working on integrating the Android...
I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
When use the "nRFBeacons" app to update the info on my beacon the following happens:
Go to update tab.
Select "Connect"
Press "SW2" on beacon and see the LED begin flashing...
I am using s110 and nrf51822. I've set up up a long characteristic of 154 bytes.
Sending between 1 and 154 bytes works as expected.
Sending 155 - 160 bytes gets rejected...
I am trying to merge ble_app_uart peripheral example to ble_app_uart central to make it as to work both central and peripheral at a time.
I am using nrf52 boards and SDK15...
ble_sdk_app_blinky
Test using nRF Connect
You can also test the application with nRF Connect by performing the following steps:
Compile and program the application...
Hello Nordic support team, I broadcast data each 1 second and I use the following function (as used in many examples) to manage the power consumption. Unfortunately, I measure...
In your example you use as data type 0x09 and I dont understand why.
if I look on the Mesh Specification Mesh Beacon AD Type format
0x00 Unprovisioned Device beacon 0x01...
Hello, i have a central card nrf52840 and several peripheral cards nrf52840.
I have a program that allows me to launch the timer on the central and peripherals at the same...
Hello, I am using Linux as a central and I created python app (bluez, pygatt) which simulates the Android Blinky app. It communicates with the board and writes on the led...
Hello,
I have just started out looking into BLE and have read various articles and a book about the protocol itself. I have got a NRF52DK board and am working on a project...
Hello,
I have a problem with the NRF9E5 (cannot be selected in the list).
For several years we have been using the mentioned chip without any problems. Now we want to...
I am using BLE mesh SDK V1.0.1. I want to know the answers of following questions,
1. What are the advertising and scanning parameters used for flooding in Mesh?
2. Does...
hey, how can i get on the device pca id which is also printed on the nordic chip on the board.
i use the mesh light on off example and need this id to send beacons with...
The code was already done in another system and it worked successfully.But when I tried to build the same code in my system it shows some error like this "cannot move location...
Hello,
I have brought new PCA10056 board for BLE5 evaluation but hard part is board is not getting detected in nRFgo studio nor in Keil.
I can see COM port getting generated...
