Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
hi ,
We developed a BLE slave device with NRF52840.
Well, we are doing product certification, BQB CE FCC, etc now.
One of the items is the 2m rate test, and we want...
Hi nordic members,
I am using nrF51822 board. I want to inform you that i am getting error undefined symbol: __data_start__ at compile time in segger embedded studio for...
Hi Nordic,
For battery_level measurement on the SDK we are using a timer such that for every 5 seconds or 10 seconds if the timer expires then the saadc will be triggered...
Hi!
I use nRF Connect Bluetooth Low Energy application for scanning. There are not all BLE devices on the device list.
The device that is not displayed on the list send...
It is required to track/locate the position of a bluetooth mesh node. I found that RSSI value can be used to estimate the distance between receiver node and a target node...
I am experimenting with the Ebyte E73 module which is just a nRF52832 chip combined with capacitors, resistors and xtals. I also have the J-Link lite cortexM programmer. ...
Hi I'm using nRF5 SDK for mesh. with DK PCA10040.
I want to read the temperature sensor reading on button press. Please give me guidelines on implementing this.
Thank...
Hello, i am testing the mesh SDK 2.2.0 version, whit the Light switch proxy server and proxy client examples.
I made a network whit 3 servers, those configured with the...
Hi all,
Is it possible to connect an external antenna with better gain to nRF52840 dongle (pca10059) in order to improve the range?
Thank you,
- Manuel Montenegro.
On SDK 15.2, all example have issues with all IDE on all NRF_LOG_INFO or NRF_LOG_DEBUG statements. Its an Eclipse issue as everything still compiles fine. But I can't track...
HI
I used the sniffer to get the packes of the connect, but I have some problem. As the Fingure indicats, The master set the Interval to 10ms, but the Packet Says the Interval...
Hello,
I have 2 nRF52840 Dongles. I am trying to use one to transmit 2.4GHz wireless signal and the other to recieve wireless signal and read the connection strength ...
