Hello,
I'd like to ask what is the data rate when using BLE OpenMesh network and how much it depends on network architecture.
I'm considering using it in a network consisting...
Hello Nordic Community,
I need to know how to import my PCB design from Eagle to CST Studio to simulate it and I need to know if the simulation step will be useful to enhance...
Hi.
I'm trying to get Apple notifications to nrf52. And specifically to listen both regular ANS (for android) and ANCS (for iOS) events depending what sort of phone is...
I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi,
I use STM32F103 as a receiver.
I read FIFO STATUS and STATUS register then execute FLUSH_RX command through SPI.
I continuously read FIFO_STATUS and STATUS registers...
Hi,
I asked previously about power efficiency for the NRF52840 SDK version V15 ( https://devzone.nordicsemi.com/f/nordic-q-a/36083/maximal-power-efficiency-in-main-loop...
I have an idea to open the source code of my personal project, since some source code of SDK are used and modified, is it OK to include the modified SDK source code in the...
I am using nrf52 developmemt kit. I am using mpu9250. the odr of mpu is 100 Hz. i am able to send data over ble using example code nrf5-ble-mpu-data-ready-interrupts . Now...
I' m using the nRF51 Dongle (PCA10031) for the evaluation of the OTA DFU bootloaders of SDK15.0.0 with the NRF52840 PDK. Using the PC tool nRFConnect V2.3.2 with the App Bluetooth...
I'm developing a product with the nRF52840 using nRF_SDK 15.0.0 and s140 v6.1.0. Since my device is not power constrained, I want to maximize the range, so I use Coded PHY...
It is stated that the advantage of a Softdevice is that because it is a precompiled binary file it can be used without requiring any particular compiler or linker features...
Hi all,
I am using the pc-ble-driver-py python bindings to interface with my BLE peripheral.
Based on the heart-rate-collector example I could get a list of all advertising...
Hi, Everyone
My development environment is PCA10028, SoftDevice 130, SDK12.3.0
I downloaded the application using nRF5_SDK_12.3.0_d7731ad \ examples \ dfu \ bootloader_secure...
Hi, the peripheral/spi example calls for nrf_drv_spi.h, which is located in the legacy directory in SDK 15. I found this post in the devzone:
[quote userid="2116" url="...
We're trying to implement OOB pairing where the 128-bit value is received externally (not NFC). All examples I could find are NFC related and seem to require the external...
Hi, everyone. We are developing BLE project on the chip nrf52832 with SDK 15.0.0 software. In this project we are using ppi feature. During the work the program must enable...
