But now I have a new problem that is whenever I set " PWR_UP " bit in CONFIG register then it drop the 3.3 volt vcc to 1.2 volt. I don't know why its happening. Anyway, is...
This previous question about multiple advertisements seems to be related to softdevice 7. I was unable to get a similar example working in SD/SDK8
My end-goal is to add...
We are considering using Gazell for an outdoor application, i.e. lots of noise and disturbances, constantly changing environment, where the amount data being transferred is...
Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Hi,
I have been having trouble getting any read/writes going with my Infineon TLV493D magnetic sensor over i2c. I suspect it may be a cast or syntax thing that I can't get...
Hello,
At the moment we are at a point to decide, if we want to expose our loads of data in “parallel” over BLE characteristics or if we should better implement a serial...
I am trying to update voltage level in Major value of my beacon. Using nrf_drv_saadc_sample() I have called saadc_event_handler(). The event triggered for first call but not...
HI, I am trying to compile the thingy52 firmware in segger embedded studio 4.10a by following the below link,
http://infocenter.nordicsemi.com/index.jsp?topic=%2Fcom.nordic...
Using sdk12.3 on pca10040.
I wanted to test persistence so I modified the example from the SDK as follows: log what's already there. don't erase. enter new data. log it...
Hello,
I'm wondering why isn't the nRF5 SDK on GitHub yet. There have been many instances where I have found bugs or missing features in the SDK, that I have implemented...
Hi,
I'm developing an application with SDK 15 that requires multiple concurrent links. One peripheral link and several central links.
I want the peripheral link to have...
I am new to nRF,
Unable to read data using flash data storage example.
When ever i try to read it
throughs error and processor enters into error handler and hangs there...
Default startup:
Using ble_multi_lesc as my default project
Log of original connection is in attached logLOTest.txt file
Currently only 1 nrfConnect is connected and...
hiii......
i am using nrf52832 interfacing with temperature sensor using temperature sensor example program..15.2v
i want to read the temperature ..... my temperature...
I have an application where I'd like to change the advertising content every time it is transmitted. Is there any callback from the SD after transmission of advertising data...
Hello. In my application I am using nRF5 SDK 15.2.0 9412b96. I am trying to communicate with two devices on two different SPIM instances. The first device is a DW1000 radio...
Dear Sir:
We observed that everytime we use OTA to update the firmware of the nRF52, the 6Byte address will change, just minus 1 compared with before, such as
FC:AE:3F...
I am using the software PWM library (SDK12.0) with the DRV8834 to drive a bipolar stepper motor. Although the motor is working in both directions with the code below, the...
