I am an android developer and I am using your nRF Master Control Panel (BLE) product as published on Google play. Below is the link to the app:
play.google.com/.../details...
I want to build a USB dongle, so I purchased the nrf24lu1+ development kit. However, in order to program the target board, it would seem that I need the nrfgo. Is this correct...
Hi Nordic,
I would like to re/program my device using a OTA BLE Bootloader but i don't want others to copy my firmware or at least make it very hard. As far as i know there...
After modifying the ancs example to remove the data and control points, the event_connect() subfunction in ble_ancs_c.c gets called immediatly upon a connection to a master...
Using nRF51822, I define keys and pins as follows:
Keyboard key
Mouse left/right key
Mouse move (up/down/left/right)
Media play/pause key
Pin 0 Mouse...
The bluetooth device keeps getting disconnected from the app, even when its not 'idle'.
I am using the android app mentioned here .
I need help getting started to solve...
I'm using FDS together with Flash manager, and checked if everything goes alright in flash.
As per doc, I set FLASH_MANAGER_RECOVERY_PAGE_OFFSET_PAGES to FDS_PHY_PAGES....
Hi, I just try to start with the spi master example (nrf5sdk/examples/peripheral/spi) on mus PCA10040 board. I'm able to compile&flash it. It seems to be running (LED1 is...
Hi ,
I working on the getting started assistant setup but got failure when verify the GNU ARM embedded setup , see the following log :
11:32:05.867
c:\gnuarmemb\bin...
Hi,
Just want to ask what will be the effect if I will use an external oscillator (32.768kHz) with a CL nearly at max specification, let's say 12pF.
Thanks.
Hi,
Can we send a message from a Provisioner to a Unicast address in a mesh network?
I'm using nrf52832 and can send orreceive message between nodes in the mesh but I...
Using 4-bit SPI mode on the Display Controller side: SCL,MOSI,MISO ... and DCX (by which the controller distinguishes between command bytes and data bytes). There's no obvious...
Hi everyone,
Im Nicolas, from Colombia. I want to develop an IoT product, using nRF9160, but don't want to use the DK (is too big for my application). I've been reading...
HI,
I got the following log in my multiprotocol application:
SOFTDEVICE ASSERTION FAILED AT 0x00025b94
Since this address locates at softdevice, I can not know what...
Hi, i want to connect nRF52 Thingy with nRF6707 power profile kit to measure the current acquire by thingy.
How to connect the thingy to power profile kit
And also i...
I had updated Thingy:91 nRF9160 firmware to 1.1.1 using nRF Desktop Programmer. I used the "Cellular Modem" button and attached the new file mfw_nrf9160_1.1.1.zip
However...
Hi
We are developing by connecting nRF52832 to SMT32f303cb's SPI interface.
SMT32f303cb operates as an SPI Master.
If the clock frequency of SPI Master is changed to...
