Hi, I have both the nRF8001 dev kit and the nRF51822 Eval Kit (EK). We are using the nRF8001 for most of our project with the BLE Arduino SDK. But I wanted to just load a...
Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
Hello, I read an article on Nordic site about the Blend Micro:
*"The Blend and Blend Micro also natively support (with no extra wiring) all Nordic Semiconductor nRF8001...
Hi,
I have a few questions on how to receive data (from an iPhone app) as a a peripheral device on nrf8001 (with RedBearLab BLE shield).
Basically I am trying to receive...
Hi,
how do you use the jlink gdb server?
All i get is Target halted (PC = 0xFFFFFFFE),
gdb will obviously not show any helpful trace for that and continue doesn't work...
Dear Nordic guy,
I 'm developing LG product with nrf51822 chip.
I have some question.
Applcation SW timer use the rtc1 clock source.so,
When NRF_timer interrupt expired...
Hi, I'm attempting to use API 2.1.3 and am experiencing some weird issues with transmission intervals. When I use UpdateConnectionParameters to set a connection interval of...
Hi,
I want to upload a firmware using DFU mode.
If I use toolbox 1.8 app of android I can upload the new firm, but If I use toolbox on my iphone, when I push upload the...
Does the s110 stack allow retrying pairing procedure?
It looks like the stack (peripheral) always ends with disconnect upon invalid passkey.
We would like to explore the...
Dear Sir,
In SDK5.2.0 S310 HRM example, one nRF51422 act as BLE and ANT RX character.
Another nRF51422 with S210 software act as ANT TX character to send out command...
Hello all,
I want to do current measurement for nrf51822 which is flashed with my own ble application which uses some custom services. As mentioned in evaluation kit user...
Hello,
My team and I are trying to decide how to power the nrf51822. We will be using a 3.7V lithium ion battery as our power source.
I saw in another post that it is...
I am planning to use the LPCOMP in conjunction with an external reference. I would like to just use a voltage divider to create the external reference.
Are there any impedance...
I recently received a nrf51822 mbed board.
I went with the mbed board over the EK because I figured it was more 'open', without realizing exactly what mbed was. I played...
I use the SPI slave function on 51422. When I send a byte(0x31) to 51422 SPI slave from master, 51422 will back a byte (0xAA - DEF byte) to master. Why?
I send 0x31 every...
