Hi all,
I have an application where an nrf24le1 is communicating serially with another processor, using the UART at 57600 bps. I have multiple identical boards communicating...
after flash DFU program into pca10001 board, com3 is not accessible,
www.dropbox.com/.../Screenshot 2014-04-26 15.41.47.png
even after I erase all, and re upload soft...
Using S120 V 8.0.0.3 alpha, processing a BLE_GATTC_EVT_READ_RSP,
received 0x16 bytes of data but there is more to read. Next call to
sd_ble_gattc_read using the same connection...
Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
with SDK 10 I found 2 SPI libraries, spi_w5_master and nrf_driv_spi . I hesitate between them.
what' the difference between them? and what should I use when I'm using app_timer...
I saw this tutorial:
nRF51 current consumption guide
It's specifically directed to the nRF51, but I guess the principles of Tuning Advertising parameters must be general...
i'm looking to use only one timer for two independent activities:
battery service (as in Nordic examples) and
a routine to detect a certain button press pattern ...
Hi everybody.
I am makeing a custom circuit for nrf51822 CEAA. This circuit supports ANCS and DFU (nrf sdk 9.0.0). I use only external high frequency (16MHz) oscillator...
Forgive me if there is an obvious answer to this; thanks for your patience.
I'm a long time developer but new to the area of BT in general. After a day or so starting with...
Rudimentary question about DFU; thanks for your patience.
I'm developing an app for a "headless" (no buttons, no led's) ble application which will have a companion mobile...
I am trying to get the pstorage module to work with our application and FreeRTOS. At the moment I keep crashing on port_cmsis::prvTaskExitError().
The pstorage documentation...
Hi,
Nordic Community and Developers,
I am trying to measure current on my custom Development board.....But I found out that it is consuming too much current on the chip...
Hello,
I am writing here because I am trying to change some concrete values from a .hex file in order to vary some BLE and other values. I need this because I need to generate...
Hi,
I am trying to compile & run ANSC example under SDK8 in a PCA10001 board. I have programmed the SoftDevice using nRF Go Studio.
Here is the example,
nRF51_SDK_8.0...
In the nRF51 SDK startup code, in the folder toolchain\gcc, there is a file called gcc_startup_nrf51. s . I think this file should be called gcc_startup_nrf51. sx instead...
