Hi, I have both the nRF8001 dev kit and the nRF51822 Eval Kit (EK). We are using the nRF8001 for most of our project with the BLE Arduino SDK. But I wanted to just load a...
Hi,
What is the suggested method to change a pending request, and make it earlier than previously requested, without closing and reopening the session?
For example,...
Hi,
I am using a custom pcb with a nRF51422 chip, and trying to setup ANT communication between 2 modules, but the sd_ant_channel_id_set call returns an invalid address...
Hi,
To use bidirectional continuous scanning mode in ANT, I have to transmit Extended Broadcast/Acknowledged/Burst messages using ANT Msgs 0x5D, 0x5E, and 0x5F (ANT Message...
We are preparing to get BT qualification for our product, developed with the 6 stack now, however want to update to 7 when it is finally released. A comment from the testing...
What is the best way to minimize transfer in progress errors when trying to send ANT messages? I am using the S310 stack on an nRF51422. I have a busy ANT channel that is...
I'm running into a weird timing issue with a nRF24L01+ which I'm not quite sure how to work around in the general case. The basic setup is two radios, A and B. Auto acknowledgement...
Hi,
I'm trying to mimic a fully functional zigbee color light bulb using the nRF52840 dongle.
Starting with the NRF5 Zigbee example light_bulb (examples/zigbee/light_control...
I apologize if this question is stupid
I want to read data in p_adv_report. I use the command NRF_LOG_INFO ("name =% x ", * p_adv_report-> data.p_data); but it's meaningless...
I am trying to use I2C (TWI) to communicate between my custom nRF52811 board with an Arduino. Currently my program hangs at the while (m_xfer_done == false); loop as m_xfer_done...
Hi Team,
We wanted to verify Sleep current numbers for nRF52833 SoC based custom development kit.
Is there any readily available firmware to verify these numbers?
...
I'm teaching a course, using the nRF52840-DK board as the lab platform.
Students download Segger Embedded Studio and compile the "Hello World" project from the 'nRF Samples...
Hi,
I have built a prototype that has two SPI slave devices connected to it and it works perfectly. I have now tried to add an SPI SD card aswell by following the FatFS...
Hi,
I'm now using nRF52833 DK to do the AoA test. I achieved the IQ sampling for a single antenna, but when I tried to switch between multiple antennas, the IQ results seems...
Hello!
My problem is that I am getting duplicates of the ACK packets I send from my PRX device to my PTX device.
To debug this problem, I configured my PTX to continuously...
Hi Devzone:
Is there a way to designate one ram block exclusively for radio use? The reason I'd like to know is the following:
Under nRF52833 AHB multilayer section, there...
I need a specific extended panid. Refer to the CLI example and add the following program:
Through the log, the extended panid returned by the device is 0000000000000000...
Hi,
I am developing an application with to 7 transmitters (peripheral) and one receiver (central = nrf52DK), all NRF52832.
I have 1 question and one problem to solved...
Hello,
# Issue I'm using a wrapper function for logging, in which you can set callbacks, which get passed the format string, and the va_list of arguments.
I'd like to...
https://community.platformio.org/t/platformio-plus-goes-open-source-improving-embedded-development-community-worldwide/8240
Hi will this means that we can expect to see...
