Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello,
We have experienced odd problem, we are not able to scroll up or down SDK documentation at these pages on Android devices. IPHONE browser Safari works ok. Any help...
Hello,
We are planning to use RT500 MCU as host of nRF7002 WiFi chip.
We are looking into firmware update for nRF7002 chip.
I read through these documents
https...
Hi,
How can I expand the time in the red box to the total time so that I can calculate the average current with time
Thank you for all your assistance. Kind regards...
Hi, Guys.
I am developing a custom hardware keyboard using the ble_app_hids_keyboard example source code of SDK17.1.0. The basic keyboard function works well. And Caps Lock...
Hi,
I am using version S140 of an nRF52840 in an application that creates an extended (S=8) advertising beacon. For my application to comply with regulations, I need to...
On iOS 18 beta we faced a random issue: creating CBCentralManager doesn't trigger BLE permission dialog. There is a thread about this on Apple forums .
Freshly installed...
Dear support team, I see that the mater/Template (Release) example only needs 715K of memory, as shown below:
I want to use nrf54l15pdk/nrf54l15/cpuapp to compile a firmware...
I am experiencing an issue to reach the ADC Max value(4200mV) on the nRF5340(our custom board) . We are using a 12-bit ADC, 4.2V and received a reading of 3297 mV, but we...
Well, this one took me many hours of tracing to track down the root cause, so I hope it helps someone!
Note: I wasn't able to reproduce this directly with a sample included...
I'm trying to debug on the Thingy:53 platform using an Nordic DK as the J-Link intermediate. However, with NCS 2.6.1, adding ` CONFIG_DEBUG=y` to the project configuration...
I am programming with the nRF52840DKs. [Toolchain Manager: v1.3.0, IDE: Visual Studio Code (VSCode), SDK: ncs v2.6.0, window11 pro]
I am currently working on integrating...
Hello,
I am using the nPM1300 in my hardware design along the nRF52840 and a battery from Renata (ICP622540PMT) . All the power outputs of the nPM1300 are in use (LDO1...
Hi! We are currently in the process of migrating our nrf5 SDK code to NCS, on nrf52833-based hardware. After being stuck for a while on the basic init process of MCUBoot,...
