Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hi,
We are developing an IoT sensor application using nRF52832 dev kit as a starting point. We have a sensor that we need to read once every second for 10 milliseconds...
I am using the simple code below to generate a signal from a memory buffer. I cannot generate a signal cyclically. If ONE sequence is used, then the buffer is played once...
Hello,
The flash memory of my existing project originally occupied about 200kb, but suddenly the capacity increased to about 255kb.
So I checked and found that the amount...
Hi
I'm doing a project using the TimeSync library (latest version) on 2 nRF52832 development boards.
I've ported the library to my project, the time synchronization...
hi, all. I'm using nrf52833, pca10100, s140.
The flash memory capacity has increased, so I checked the memory, and it seems that the log values have been saved.
It should...
My mac (and the nRF connect Programmer) no longer recognizes my Thingy91 when I connect it via a micro-USB. I am unable to use the nRF connect Programmer to flash my device...
We have had our nRF52840 based Zigbee Coordinator in production since September of 2020 with great customer feedback. Unfortunately, we have recently had several instances...
Hi,
I am new to Nordic cellular modems, but plenty experienced with other modems. I would like to evaluate the nRF9160 as a potential candidate for future use in our products...
Hello,
I am having a problem nearly identical to this link Using soft device on custom board with nRF52840 - Nordic Q&A - Nordic DevZone - Nordic DevZone (nordicsemi.com...
Hello,
I am running a single ( main() starts sysworkq thread) thread application in Segger Embedded Studio v5.34a, built for the nRF52833 SoC.
Although I am using a proprietary...
Hi
We are seeing a strange issue when trying to use the Android BLE Library to Android BLE Library to reconnect to two devices. The phone succeeds in connecting to one device...
Hello,
I am going to run DFU over the mesh.
I am using an nrf52840DK and two nrf52840 dongles. I want to send a DFU file through the serial port to the DK and then through...
