Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hi, I am currently integrating nRF52832 with TLV320AIC3104 codec. I have successfully initialized I2C and I2S communication between the two boards and configured nRF52832...
Hello,
I am evaluating the nRF54L15 for potential use in a new product. I did some measurements of the average current consumption and the vaues were a bit higher than i...
Hello, I'm currently exploring BLE using zephyr and faced some issues.
1. id like to restart advertising after disconnecting from a device. I tried different approaches...
I have shifted from silicon labs for BLE project. In Si labs we have burn BLE bootloader and BLE application separately. Do i need to do the same here in nrf controller? If...
Hi everyone,
I'm currently working on porting a project that uses Enhanced ShockBurst (ESB) , originally developed with nRF Connect SDK v3.0.2 , to Zephyr 4.2.0 . The project...
Hi,
im trying to create a custom board file using nrf5340. we tried following the tutorial custom board creation , we copied the nrf5340dk file from the nordic installing...
Hello Nordic DevZone,
I am having a persistent problem using hardware timers on the nRF52832 with nRF5 SDK v13.
Summary of Issue:
I am using NRF_DRV_TIMER_INSTANCE...
I purchased nRF7002-DK in May and after using it for 2 months only powered by the board usb connectio on its debug port, a week ago it stopped powering on, is it possible...
Hello
I'm currently trying to connect to an AWS IoT Core broker using the MQTTX client. I'm generating the necessary certificates through the CreateTeamDevice API endpoint...
Hi,
I am wondering whether I can have one "RELAY" device in BLE communication (not BLE mesh), I have look through this forum but only saw some example 5 years ago. As I...
Hi, I wantto use this example https://wiki.makerdiary.com/nrf52840-m2-devkit/python/examples/lcd/ with my nrf52840dk . how to use this with nrf52840dk? .I have st7789v display...
Hello,
We have a custom board with nrf5340 (we are using ncs2.6.0). We are using CPUAPP, CPUNET, and MCUBoot. When we use the Nordic nrf5340 devkit, it works fine and when...
Hello,
I'm implementing the Nordic firmware upgrade using FirmwareUpgradeManager from the Android SDK ( https://github.com/NordicSemiconductor/Android-nRF-Connect-Device...
Dear Nordic support service,
I am currently using nRF21540 with nRF52840 and nRF5_SDK_17.1.0.
I am able to transmit and receive, but I am not able to switch from RX to...
