Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hi,
I am developing firmware for both nRF52832 and nRF52840 chips. For serial communication, I would like to have a common interface for both chips, which means sending...
Hi!
We are developing a beacon for a hursh environment based on NRF52832 chip and now close to production. Recently we've noticed that unit power consumption for some reason...
I want to use extended advertising features , I search ble_peripheral only one example is ble_app_rscs
I compiler and program, i can't find the device in my phone app
...
i download App(iOSDFULibrary) from https://github.com/NordicSemiconductor/IOS-Pods-DFU-Library .
And delete all firmware itself have. Put my firmware into folder (Firmwares...
Hi,
i am doing a project where i am modifying secure uart boot loader,
the problem which i am facing is while debugging into boot loader example i am not able to see the...
Hello all,
I've been modifying the thingy:52 mesh demo ( https://github.com/NordicPlayground/Nordic-Thingy52-mesh-demo) to support more sensors but I've noticed a severe...
The NRF52810, gives the 0dBm out, with 4.6mA peak current 。
When we using, we plan 20Kpcs for mass product, the current is more 4.6mA， it is 7.4mA 。
we use the 2MBPS air...
I would like to have multiple threads simultaneously accessing the modem via the AT commands over the AF_LTE socket. Thread1 does the normal AT+CFUN=1 and other active commands...
running DFU example from <SDK 15.3>\examples\dfu\secure_dfu_test_images\ble\nrf52840 , and attempting a DFU update of:
sd_s140_bootloader_buttonless_with_setting_page_dfu_secure_ble_debug_without_bonds...
Hi everyone.
I have a problem with processing with recived UART data. I'm using software UART from example > peripheral > uart.
I use nRF to comunicate with GSM module...
Hello,
how can I store CCCD values in flash?
I read that the peer manager handles it ,but when i reset my device and load all bonded peer data, the CCCDs are not set....
Hello everyone,
i'm trying to hook up an external i2C sensor to P5 connector (TWI_SCL_EXT, TWI_SDA_EXT) and created a device driver template ( from drv_gas_sensor.c example...
What is the max amount of data that can be saved in records in fds?
When we do a dfu, is the data conserved or not?
How to vary the size of the records if possible?
...
