I'm having some trouble successfully entering ON,IDLE mode. I have pared-down my application to do the following:
Initializes the app_timer using the scheduler:
...
I want to control GPIO toggle by PPI. Timer1 is in timer mode. CC[0] is 1000, and CC[1] is 8000.
I use compare[0] to toggle gpio18 by PPI. I also want to use compare[1] to...
Hi,
I use two evk board to connected and test the uart serialization sample(ble_s110_serialization), one is ble_app_hrs and one is ble_app_connectivity. But I have one...
I am getting get BLE_EVT_USER_MEM_REQUEST and BLE_GAP_EVT_CONN_PARAM_UPDATE event, when writing to ble device, sample code did not handle these event, and seems no document...
Hello:
Why do I erase SDK5.2 version of flash and read not, in SDK4.2 can. I tested nrf51_sdk_v5_2_0_39364\nrf51822\Board\nrf6310\flashwrite_example is a good example.However...
before i write the flash, it has been erased.so ,its value is all 0xff.
when i write 0x00 to flash address 0x0001,the value read out is not 0x00 but 0x01,and the value in...
Hi,
I am trying to implement a Thread Border Router on Raspberry Pi 3 with NRF52840DK as a Network Co-processor (NCP).
I have followed the below steps to install the Thread...
Hi
I succeeded in changing the channel mask in the advertize_init function, but I could not change it in the middle of the function.
For example, I want to change the...
Hi,
I am new to Nordic product. I bought nRF52840 board and DWM3000EVB board from Qarvo for building some UWB project. I checked this forum a little bit. But I still did...
Hi,
We are using iBeacon to locate the relative position of mobile phone between two beacons.And the distance between mobile phone and beacons no more than 20m.
Is that...
Hi there,
We are looking for an example application for the nRF5340 DK that runs a very basic baremetal application. All sample applications seems to be using the Zephyr...
I have been working with nrf52 to produce unix time stamp but it using the rtc is a tougher task. Hence, Please help in providing a header file that has a macro such as time_t...
Hello,
I’m using the secure bootloader for serial DFU (UART, not USB). To enter bootloader mode from the application, I write 0xB1 to GPREGRET, then call NVIC_SystemReset...
Hi,
I want to automatically load the value of POUTA_UICR into TX_GAIN at startup. The program code writes the setting value according to the steps on page 14 of the manual...
Hi,Nordic Friends,
I'm using nrf5340dk,and my project need commnunicate with NB-Iot Modem over uart.Now, I found the dirver that i can use directly.But When I configed the...
Hello All,
My company has recently decided to switch to Nordic at the direction of one of our suppliers. We are very impressed with the devices offered and the available...
I use a nRF5280 DK to get DFU working.
I connect to the DFUTarg, Click the Start Secure DFU icon, select my app_v3.zip file, click Start DFU
I get this error during...
Hi there!
I just switched from the GPS Library to the GNSS API.
The problem is, that we never get the timeout event NRF_MODEM_GNSS_EVT_SLEEP_AFTER_TIMEOUT . Basically...
