Hello：
Why Bluetooth Go to system-off mode, sd_power_ramon_set can not be stored. In D: \ RAM save nrf51_sdk_v5_2_0_39364 \ nrf51822 \ Board \ nrf6310 \ s110 \ ble_app_rscs...
Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I have recently ported our working project to SES. The project uses S140 with nordik SDK 15.20 on nRF52840 custom board. the project also makes use of freeRTOS. It's important...
Hello,
mqtt_simple was probably never tested in TLS because some parts for TLS are missing (see client_init)
Could you make a good exemple that works please ?
hi...
I am working with thingy52 while compiling i am getting this error , then i moved to segger , in segger i am getting following errors
how to overcome this ? help...
Hello -
We are interested in using NimBLE for a nRF52 project as we've used NimBLE on another micro controller. NimBLE would be running on FreeRTOS and we are developing...
Hello everyone,
I'm trying to generate a periodical sine signal at the output of a 10 bit DAC without CPU interaction. The DAC uses an SPI interface, thus my idea was to...
I am trying to run adafruit_tag_reader example on nRF52840 DK .
Problem :
If these are my pins in sdk_config.h it works fine
Whereas this doesn't work.
nrf52832 softdevice S132 SDK15 custom board
TWI instance
TX(nrf_drv_twi_tx) failed, slave device is AD5252 digital potentiometer, i want to send data to the potentiometer...
Hi Sir,
I want to sent specific message to a defined server with a static ip configured. Kindly let me how we can do this in nRF9160 with NBIOT network.
Regards, ...
Hello,
we starting the production of first lot our devices on NRF52840CKAA (WLCSP).
We get some issues with manufacturing, which can be separated into to 2 parts:
...
Hello! When building the firmware for Thingy:52, at the stage of building with vkpcg, I get the following errors:
C:\Users\Owner\source\repos\vcpkg\toolsrc\src\vcpkg\base...
I'm experiencing a strange issue with the USB CDC example when connecting the nRF52840 to Windows 10. This is with the 15.2 SDK. I'm using the usbd_ble_uart example on the...
Hi there,
I’m having a problem very similar to this post: https://devzone.nordicsemi.com/f/nordic-q-a/49159/jlink-dll-reported-and-error
I am using the Nordic nRF52...
Hello.
The power supply switch of our product is hold by nRF9160.
The whole product will lost power if nrf1960 being reset or the power control pin is released by nRF9160...
Hello, I've set up the image transfer app from Nordic Playground with the idea in mind to remove the Android App from the equation. I've picked through the Android app itself...
