Hi,
I use two evk board to connected and test the uart serialization sample(ble_s110_serialization), one is ble_app_hrs and one is ble_app_connectivity. But I have one...
I am getting get BLE_EVT_USER_MEM_REQUEST and BLE_GAP_EVT_CONN_PARAM_UPDATE event, when writing to ble device, sample code did not handle these event, and seems no document...
Hello:
Why do I erase SDK5.2 version of flash and read not, in SDK4.2 can. I tested nrf51_sdk_v5_2_0_39364\nrf51822\Board\nrf6310\flashwrite_example is a good example.However...
before i write the flash, it has been erased.so ,its value is all 0xff.
when i write 0x00 to flash address 0x0001,the value read out is not 0x00 but 0x01,and the value in...
I'm looking for a way to use the nordic uart service ( devzone.nordicsemi.com/.../ble_sdk_app_nus_eval.html) from Linux using the native Linux BLE Stack (BlueZ). My application...
Hi,
I've created an application using the S110 experimental ANCS demo. I successfully implemented ANCS and then began to structure my application around it. At some point...
I'm using pc-ble-driver(C program) to get the data from other device, I can get character now, but I don't know how to turn on the character's notification like the start...
We wanted to implement both BLE and serial DFU on nRF52832 without serial flow control. The main procedure is as follows:
Use the Nordic BLE DFU example as a start...
Hello,
I am using nRF52840, SDK_16.0.0, S140 SoftDevice and Segger 4.16 for flashing the image. I am using ‘ble_app_blinky’.
I have queries on enabling HW crpto accelerator...
I'm implementing the device side of the DFU-protocol (v16) (Control Point & Packet) using the nFR Connect Mobile as DFU Controller. In the app I select Application as file...
Hi All,
Since 2 weeks I try to configure a gap with a "raw payload" but it's a Chinese puzzle! Between different SDK, with different "Soft Devices" and examples dating back...
Hi,
I've install the throughput example (examples/ble_central_and_peripheral/experimental/ble_app_att_mtu_throughput) on an nRF52840-DK and I test it against all kind of...
I made 20 pieces of porototype devices. Testing some damaged them, NRF52832 does not work and the voltage on them is 1.556V, others work again but after disconnecting the...
Hello All,
I am trying to publish the data gathered from UART using MQTT . So far I was able to get serial data in the inData buffer. I am not able to publish data automatically...
To the kind attention of Nordic support team,
According to your valuable experience and manufacturers' capabilities, having the package a pitch of 0.35 mm is it possible...
I use nordic 52810.
I am trying to use s112 and HW IIC but I got the compiling error:
twi_hw_master.c:34:5: error: 'NRF_TWI1' undeclared (first use in this function) ...
I have a nRF52840 based product prototype which includes a power management integrated chip (PMIC) and a Li-Po battery.
The product recharges via a USB connector. The USB...
I am always getting the same issue on each sample I try to build. Not only on this "lte_lc.h". This error is also shown with several files or on the code lines....
Checking...
