Hello,
I have tried twice to request for SUPL license for getting A-GPS working but it has been denied both of the times. I think first time it got denied due to mismatch...
Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
I would like to use a Bluetooth protocol analyzer for sniffing traffic in my Mesh network. I need to input the devkey(s), netkey, and appkey to the protocol analyzer software...
Hi,
I am adapting the uart example to send mensages between central and peripheral using JSON. In this moment I can send central <------>peripheral...
I have a problem...
HI I'm developing Mesh network with SDK for mesh 1.0.1.0
I just started with own provisioner code bud a really need some debug print while programme running.
I tried a...
i have created whitelists for filtering connection its working fine now, but when i restart my firmware the stored whitlists data become cleared so i need to bond each time...
Hi All!
I use "examples\peripheral\usbd\" example Project as reference to implement my own HID protocol.
I use only EP1 in/out 64 bytes both.
faced with a question,...
Is it possible for a peripheral device to start a Bluetooth Low energy advertisement and then read the RSSI value in the advertisement packet that it sent once a connection...
Hello,
I have some trouble to use fstorage function with dfu function,
please help to let me know the solution in order to solve the following issues,
thankful for...
Hi,
I'm getting back "01 10 06" when attempting to send 0x01 Start DFU to the DFU Control Point from my gateway which is a Pi3 running Noble. Notifications are enabled....
Hello, i've read in the infocenter that there is/will be a new nRF52840-PDK Hardware (v0.11.x). Is it already available? If yes, who distributes it? If no, when will it be...
nRF52832 SDK 14.2
Hi.
I would like to know how I can run a function in the background? In my case, I want to process a queue in the background. Here is the scneario: ...
Hi all,
after call inside the BLE_GAP_EVT_LESC_DHKEY_REQUEST I got error 8, what can cause it? a CONNECTION_SUPERVISED_TIMEOUT?
device nRF52, SDK13
Thanks
Board: custom board; Mesh SDK: V1.0.0; Softdevice: S132_5.0.0; IDE: SEGGER Embedded; BLE: nrf52832
When I test the example “Interactive PyACI”, I need one node(A) send message...
