I have a working project where pin 16 is configured as a low-level interrupt source.
it is working well with SDK 15.3
after porting to SDK 17.0.2, it is not triggering...
Hello Nordic Support Engineers and fellow developers ...
Just a note to thank everyone for help via this forum. I started very inexperienced with Nordic SDK a year ago and...
Hi,
I recently purchased a thingy91 for a project. I'm trying to follow instructions from a Nordic youtube video ( https://www.youtube.com/watch?reload=9&v=xQ7hDzRULJQ ...
I have a nRF5340PDK, Now I want to know the lowest power consumption of this chip in different condition, such as adv, connect, sleep. But I am not sure how to config the...
Hi, i am using:
-nRF 52 DK
-nRF 52832
-Sensor of Maxim Integrated
-SDK 17.0.2
I have some problems in handling the I2C through the nrfx module.
This is my ReadByte...
Hi, I have a set up consing of an nrf52840, a Raspberry pi and a Linux workstation, which communicate over IPSP following the IPSP sample from Zephyr OS. The nrf52840 is a...
sdk ncs v1.3.
Example name: serial_lte_modem. Example path: D:\ncs\v1.3.0\nrf\applications\serial_lte_modem
The error in opening this sample macro definition is as follows...
Hello, Nordic developers. The ZED , ZR and ZC connections were identified by the example of Zigbee Light Control example .
Based on this example, we are going to develop...
I am using the gazell protocol of nrf52840, How can I specify the correspondence address of this different handles when I USE A HOST to communicate with eight handle devices...
Hi,
I have looked at the different post regarding the nRF9160 and SPI, but I can not get it to work on our custom board.
Attached the board definition files.
Here...
I have the Thingy91 plugged into a macbook pro(osx catalina) with usb.
I have updated the firmware on thingy 91 with the precompiled application and modem firmware ( 2020...
We are able to form a openthread mesh using CLI-ftd examples.At present we have server communicating to Clint in UDP portal .Is there is any UART command which is meant for...
Hello.
I am using SDK v17.0.1, nrf52833.
I can enter DFU Mode with pressing Button 4 and reset Button.
However, I want to enter DFU mode without any Button.
I've...
Hi everyone,
I'm starting from USBD example and I want to implement a composite device.
If I want to implement a composite device I have to add one interface and then...
I'm working with several Samsung SmartThings and I am wondering if a call to will address this the issue of devices leaving the network insecuely https://www.samsung.com/sg...
Hello everyone, The last few days I was advised to buy the nrf52840 DK. Up to now I have worked with the dongle. I read online the need to download the j-link software. Where...
Currently, I'm switching my platform form nRF52 to nRF53.
For the work I'm doing, I need to use DPPI to enable GPIO events to trigger SPI transmissions, without interrupting...
Hello,
Looking for some background info for SOFTDEVICE ASSERTION 0x0002715e. sdk 15.3, SD s132_nrf52_6.1.1
Maybe related, there is no Assert if fds_record_write() is done...
Hello
I am developing devices including nrf52832 and 3.3v buzzer. However, the buzzer in this device is very hot and the battery is running out quickly.
Now I know that...
