Hi,
I have a SPI slave device which outputs 8-bit registers that I have to assemble. For example, I receive two 8-bit registers, a high and a low register, which I have...
I have a PCA10059 dongle. I have inadvertently configured pin P0.25 as the sleep debug pin and I use active state 0 as I am using off board LEDs with reverse logic. This means...
If you're working on a product that requires you to show and translate GATT Attribute (Service, Characteristic and/or Descriptor) UUIDs to Strings to the user, it's likely...
Hello,
We have been trying the sendNotification call and after getting a success log we are not able to send a second notification. I'll copy the snippet of code that we...
I have a firmware developed on the nrf52840 development board. When porting it to nrf9160, a lot of errors were reported. How can I use the LOG output function on nrf9160...
Hi I would like to ask you for advice on how to solve my problem with Ble and the timer I am trying to add a timer to examples\ble_peripheral\ble_app_uart the timer works...
During some FA on a customer complaint on a pre-production system it was found that delays in receiving HVX notifications on the central side were linked to having a currently...
Hello,
I need to have a nrf52932 working as central and peripheral. So I started from the ble_app_hrs_rscs_relay example. It works fine, I can connect to my iPhone and get...
Hi,
My customer have problem at tuning audio search based on SR3 reference code.
We would like to use the audio probe to record the raw wave file.
However , we knew...
Hi,
Can anyone from Nordic share some example code for enabling AGPS on the nRF9160? I see that the updated bsdlib landed about a week ago in nrfxlib.
Specifically...
Hello,
I am testing 9 channels for PER (1,2,3,21,22,23,37,38,39). During testing the last 3 channels I always get a single time out error in response to LE_TEST_END. I...
I am having quite a frustrating time trying to make SPI drivers compile into a 52811 project I already started, so I thought I'd back off, and try to just get an SPI example...
Tried to flash ncp .hex for pca10059 on a brand new dongle and now it is stuck in dfu (pulsing red led). The process worked on a second dongle without any issues.
Something...
Running nrfconnect320x8664.AppImage on Linux (SuSE Leap 15.1). Read "Getting Started" but that was of little help!
So, following my nose.. On the Apps tab of application...
HELLO,
I am trying to generate a 125kHz pwm siginal using nrf51802（sdk version12.3）. I use the oscilloscope to observe the wave form.I change the macro value of PERIOD_IN_US...
Hi,
I am developing an app for PCA10059 board. my app works well but after sometime and saving some data on flash, boards keep resetting and did not booted(LD1 blinking...
Does anyone have experience in porting both embedded and android code from the 13.1.0 SDK to 15.x.x?
I'm running into an issue where the system worked fine on 13.1.0,...
Hi,
I am actually tring to migrate a project from Keil to Segger Embedded Studio (SES) and i have a problem with the build of my project when tring to build ecc.c.
The...
