hi dear nordic employee:
I tried to build the project ble_app_hrs_c（pca10040） by keil5
but I get an error :
._build\nrf52832_xxaa.sct(7): error: L6236E: No section...
Hi,
I am a bit confused about power consumption when using app_uart_fifo. To save power I put MCU to sleep in between each sent and received byte by using __WFE and __SEV...
Hi! I am building an android app for my project. I am using Proximity , UART and DFU from nrfToolbox app. I have 3 buttons on my home screen dedicated for each of them. I...
Dear Nordic employee:
1、 what do I have?
I have a thingy52 develop kit（nrf52832）
2、what is my purpose?
the quality of thingy52 audio demo is not good（iphone7）...
Hello Nordic,
My development environment:
SDK>> NRF51822_SDK10, SoftDevice>> S130
Example>> ble_app_uart
I am looking forward to your reply!
Thanks.
Best Regards...
Dear friends,
according to "nRFConnect_BLE_User_Guide_v2.0", to set up a local device,i should complete the following steps:
Connect a development kit or dongle to...
Hi
I have add some function call like sd_ble_enable in mesh example, I test to get
then I set the address and all sd_ble_cfg_set is ok
but when I call "sd_ble_enable...
Hi everyone,
I am new to nrf community. Currently, I am trying to develop an IR transmitter on NRF52832 DK which transmits HEX codes for IR (not raw data). I am unable to...
Hi there,
I worked myself through the Matter DoporLock example including commissioning into a Thread Network using OTBR. I find manually obtaining the credentials from the...
Hi All
Do you know of any Mobile devices/Apps supporting Bluetooth5.1 and Direction-finding currently on the market (or planned to be)?
Is it going to be added to nRF...
err_code = sd_ble_gap_adv_start(m_adv_handle, APP_BLE_CONN_CFG_TAG);
nrf_pwr_mgmt_shutdown(NRF_PWR_MGMT_SHUTDOWN_GOTO_SYSOFF);
I would like to ask that for the above...
Hi there,
We have a mesh network which runs now for quite some time on our own hardware. We are using heartbeat messages to collect RSSI values between nodes in the network...
Hi Dev team,
I was looking through the documentation of PMIC from the Thingy91 User Guide and I saw that the PMIC in Thingy91 can be used for battery charging (" The PMIC...
Hi,
I do not get any neighboring cells reported using this command. Is one particular state required to receive information regarding neighboring cells?
-Marius
Hello world :-)
I am writing I2C temperature sensor driver over `i2c0` working in `twi` mode in Zephyr with my custom `dts` board configuration and this pops up on the console...
The current platform of the AOA contains 12 antennas multiplexed into one 52833 module
The distance between each antenna is small, hence the angle delta that can be detected...
Hi Nordic Support Team,
It can connect and read the Service UUID and Characteristics UUID, but when I am trying to do the DFU update on the iOS (iOS 14.5) but it will disconnect...
Hi,
I am developing the system where I am sending the data of three sensors to the server using MQTT. For the above development, I used two microcontrollers one to collect...
