Nordic \ nRF5_SDK_12 nrf52832 using 2.0 _f012efa \ examples \ peripheral \ pwm_driver, pwm_driver example
Want to set up two road PWM phase is different, for example, the...
I'm using nRF52832 and S132 based on nRF5 SDK v14. I get a error code 4 when I add DFU service refer to the experimental_ble_app_buttonless_dfu . The SDK has changed so much...
Hi,
I'm wondering if I can get current transmitting channel during a connection. So
Is there a way I can directly read current transmitting channel?
If not, is...
This question has to do with the observed "recursivity" of the calls to "app_sched_execute" in SDK13 as described in the previously asked question below:
devzone.nordicsemi...
hi.
How do i do ble_app beacon advertisement to one device(Android phone) whose bluetooth address is known ?? I want that beacons should only be seen in nrf_connect app of...
why use 50ms and 400ms connection interval for testing the maximum data throughput(2M,247byte payload)?
Because 50ms can only send a pdu , and 400ms can send up to 8 pdu...
Hi,
I am using Keil IDE to develop nRF51822 project.
in main(), the command line
APP_SCHED_INIT(APP_SCHED_MAX_EVT_SIZE, APP_SCHED_QUEUE_SIZE);
has Error : L6218E...
Hello, nrf5340 datasheet -> nRF5340_OPS_v0.5
section: 7.1.26.7 Sending custom instructions (Page: 383) 1. we can send an instruction consisting of a one-byte opcode and...
I kind off trying enable TWI in bootloader mode, This is because of following reasons.
Firmware is stuck in bootloader, if somebody removes the Device Battery during...
Hi.
I'm trying to run an application using a custom SPM module in a nRF5340 where I get an error while running it. I'm using nRF Connect SDK. The terminal gives me this...
Hi
I have searched this question on the website before posting this and found that the nRF52 devices support SWD interface (which is peer to peer) and not JTAG (which...
Hello,
I was able to install all tools proposed by the nRF Connect v3.7.0 except the most important : Toolchain manager.
It retruns the following message
running...
Hi, I am interested in using the KMU and I have seen some examples of it here (9160 but similar): https://github.com/einarthorsrud/kmu_sample
and also some docmentation...
Aim: To upgrade the existing Bootloader + Softdeivce + Application package build using nrf_sdk_15 to nrf_sdk_17 on the NRF52840_DK.
Problem: I successfully flashed the secure...
We are using zephyr on that nrf52840 .
Is possible tu run code coverage analisys on that board ? What I have to do ?
Does twister work ?
Best Regards
Novelo G
My technical questions are as follows:
1) I need to upgrade an old iBeacon transmitter we design using the nRF52832 with SDK 11 (Sofdevice s132_nrf52_2.0.0_softdevice.hex...
Hi,
I have develop the Code based on HID_KEYBOARD AND NUS code
here i also need to ADD NVS and DFU to nrf52840 device
1. Pair device address is stored in what manner...
Hello, I'm using SDK 17.0.2. I want the documentation in PDF format. I was unable to generate on PDF document for all documentation. Is there a PDF that I can download?
Hello, I make multii-link peripheral device with 3 BLE HID connections. I extend heap and stack to 16kb and set properties RAM_START=0x20004000 RAM_SIZE=0x3c000. As the base...
