hi dear nordic employee:
I tried to build the project ble_app_hrs_c（pca10040） by keil5
but I get an error :
._build\nrf52832_xxaa.sct(7): error: L6236E: No section...
Hi,
I am a bit confused about power consumption when using app_uart_fifo. To save power I put MCU to sleep in between each sent and received byte by using __WFE and __SEV...
Hi! I am building an android app for my project. I am using Proximity , UART and DFU from nrfToolbox app. I have 3 buttons on my home screen dedicated for each of them. I...
Dear Nordic employee:
1、 what do I have?
I have a thingy52 develop kit（nrf52832）
2、what is my purpose?
the quality of thingy52 audio demo is not good（iphone7）...
Hello Nordic,
My development environment:
SDK>> NRF51822_SDK10, SoftDevice>> S130
Example>> ble_app_uart
I am looking forward to your reply!
Thanks.
Best Regards...
Dear friends,
according to "nRFConnect_BLE_User_Guide_v2.0", to set up a local device,i should complete the following steps:
Connect a development kit or dongle to...
Hi
I have add some function call like sd_ble_enable in mesh example, I test to get
then I set the address and all sd_ble_cfg_set is ok
but when I call "sd_ble_enable...
Hi, I was wondering how to change from central mode of the NRF52 board to peripheral mode and from peripheral mode to central mode by pressing the input buttons on the board...
In the blinky-central example, on_ble_evt() switches over both BLE_GAP_EVT_DISCONNECTED and BLE_GATTC_EVT_TIMEOUT .
Why is this required? Won't a client GATT timeout...
Hi,
since the nrf52 offers the capability of NFC and BLE I am interested in methods a customer could use his smartphone for payment. Is there a common way or open standard...
Hi all,
I have programmed my chip nrf51822 successfully using stlink and the openocd. I have burned the same hex file which is there in the example that is the ble_app_uart...
Hi,
I've been trying to port my project from SDK10 to SDK12. I'd thought this would be a simple process. Definitely simplier then when I ported from SDK6.1 to SDK10. However...
I would like for the nodes in the network to be able to talk to any other node, even if the other node address are not pre-configured.
For example, I would like to be able...
Hi, Nordic
Now I have one nRF24LU1P USB Dongle, if sometimes there is no data in/out usb(maybe 3ms), USB Dongle will enter suspend state.
Can USB Dongle support to resume...
I am building the ble_app_hrs_freertos example code for a pca10040 dev board located in the SDK 12.2 at: nRF5_SDK_12.1.0_0d23e2a/examples/ble_peripheral/ble_app_hrs_freertos...
Hello guys,
I'm working in a project which requires from me to bond to certain devices and refuse the bonding from others, I mean at certain input, connect to anyone and...
Can I expect the call to sd_flash_erase() to successfully erase a page of flash while I have an ANT channel open doing a low priority search?
What about when doing a BLE...
Hi there,
Is it possible to use TWI0 and SPI0 (or TWI1/SPI1) time multiplexed?
When enabling them both in sdk_config.h I get "Error: L6200E... IRQHandler multiply defined...
