I want to verify the 4Mbps transmission mode of the nRF54L15 series through ESB samples.But the highest value measured so far is 2.34Mbps, which is much lower than 4Mbps....
Hi, nordic team
There is an issuse happened in my custom board with nrf52833,programming in ncs v2.9.0.
peripheral side is programmed base on peripheral_hid_keyboard and...
Hi all,
We are currently developing a modem application for use with a Linux host, based on a nRF9161 using nRF SDK 3.0.0 and toolcahin 3.0.1
When compiling the Serial...
Hi,
I'm using nRF SDK 16 for my application on the nRF52840 custome board. When I set both parameters (i.e., support for coded PHY and 1M PHY ) in the scan initialization...
Hi all,
I'm working on a Nordic-based system involving multiple nRF52-series chips exchanging high-rate sensor data over both radio and SPI links. The setup involves two...
Howdy!
I am attempting to develop a system using an nRF52840 and an ADS131M04EVM (ADC). Our application requires us to collect data at a high sampling rate (>= 16k SPS...
I have a nrf9160 DK but when upload SLM application to it i can not send AT commands to it over it's usb port but in asset tracker application it works i want to modify SLM...
hi,
i am newer here.
i am confused in nrf_gpio_pin_sense_t i.e. NOSENSE, HIGH_SENSE, LOW_SENSE.
where is use of this feature ?
why it is required instead gpio_input...
In my application many nodes (acting as centrals) will start simultaneously, as they have common power supply. I am using s132 SoftDevice (4.0). Is the frequency hoping sequence...
Hi experts,
Can we add capacitor to the swdio pin to improve ESD capacity?
We have make some sample that add 1uF capacitor to the swdio, indeed have improved the ESD capacity...
hello there i want to use c++ library in nrf51dk project. i am using sdk12.
i change main.c to main.cpp
but i am getting error. uart_original.rar
i have uploaded code...
We are planning to use two modules at the same time one for esb and one for standard btle, because the esb is time critical and timeslot api seems to be to low priority. Do...
Hi,
I am using NRF52 DK board. I use nrfjprog under windows to flash controller. But i want to flash under ubuntu. I searched but i found one .rar file.i extracted but there...
This is probably a sign that I should upgrade to nRF52 (with a built-in FPU) but, in the meantime, does anybody have an example of the libfixmath library integrated with an...
Hi everyone,
i have J TAG V8 and when i am using this with keil software and try to debugging then its showing-
"The connected emulator can not be used with this software...
I found in documentation that the time to write to flash is between 67.5 and 338 µs.
What conditions influence this time?
-How to avoid long writing times?
I have four wearable devices.
Each of them have 50HZ sample rate, and data length is 20Byte.
I don't want to lost any data, so I want to use indication instead of notification...
Hi, In my application I want to communicate between 2 nRF51822 boards use esb_low_power_prx/esb_low_power_ptx example in nRF5_SDK_11. I have a problem when setting PTX
...
