Hi, is there an available developer in my tri-state area of Minnesota, N. Dakota, or S. Dakota? Please call me if you are available for a project for hire. The developer should...
I'm trying to design a very low power sensor that takes readings using ADC and SPI 200 times a second. I'm a bit worried by the current EasyDMA uses (1.1mA). As far as I can...
Hi, I am working on a project where I want to make one nrf51288 chip as central hub and connect that to a android phone and other salve nrf51288 .
idea similar to this: ...
Hi,
I have a code programming the nRF51422 development board to write to a Sharp Memory 96x96 pixel LCD screen using SPI.
Currently the code writes two numbers and a...
I've modified the ble_app_uart example by adding GPIOTE so that the transmitter sends a character to the receiver when a GPIO pin is toggled. This part is working well.
...
Hi,
I am working on my hardware product having nRF-51422 chipset. I just came to know from forum post that
nRF-52 chips will get arduino IDE support as standalone. I want...
Hi!
I've been using PCA10028 for a long time and I had some bricking issues but I've managed to un-brick it with "nrfjprog --recover" and everything would work again. ...
Hello, I was reading through the OpenThread Commissioning Guide ( https://developer.nordicsemi.com/nRF_Connect_SDK/doc/latest/nrf/ug_thread_commissioning.html ) Attempting...
Hi
I am interested in the Non-IP Data Delivery support in the nRF9160 module.
1) Is there or is there no support at the moment? If not, is it planned and when will...
Hi,
My program suddenly stop working and I get this error message
This happening when I want to go in Debug Mode (Debug > Go).I cannot start the program anymore.
I...
Hi Nordic Team!
I am working with nRF5340 DK and nRF Connect SDK 1.5.0
I wanted to use Firmware Upgrade (FOTA) feature with the mesh . So, I have started with Bluetooth...
device_get_binding() this function has many parameters ,very Incomprehensible to use, in the nordic samples i use debug step by step to find what port what pin to be used...
Hello,
I am looking at the schematic for the nRF5340 DK and see that there are no external load capacitors for the 32 kHz crystal which has C_L = 9 pF. Therefore, we are...
Hello!
Hardware: nrf52840 IDE: Segger Embedded Studio SDK: nrf5 SDK 17.0.2
I've been having trouble getting IN reports to work on macOS. I based my code off of the generic...
At present, the nrf52840, sdk package is components_V15.2.0, it will restart probabilistically when the USB is connected to the computer for charging. The hardware reset register...
I use nrf52840 and max30003 and SD card that saves my ECG data. I've tried to make a lot of ECG and this one is the best. But I don't know why some ECG PEAKS are positive...
2021 05 18 west update new source mkdir -p ncs west init -m github.com/.../sdk-nrf --mr master ./ncs cd ~/ncs west update west zephyr-export //// ~/ncs/nrf/west.yml
name...
HI
When I use thread networking program, p0.7 pin is not controlled as IO port, but it is used well in other programs. What's the matter?Is this pin occupied by thread networking...
I already had a look at the custom characteristic tutorial and have completed it. Populating the Sensor value with characteristic is the next step where I am facing trouble...
