Hi, is there an available developer in my tri-state area of Minnesota, N. Dakota, or S. Dakota? Please call me if you are available for a project for hire. The developer should...
I'm trying to design a very low power sensor that takes readings using ADC and SPI 200 times a second. I'm a bit worried by the current EasyDMA uses (1.1mA). As far as I can...
Hi, I am working on a project where I want to make one nrf51288 chip as central hub and connect that to a android phone and other salve nrf51288 .
idea similar to this: ...
Hi,
I have a code programming the nRF51422 development board to write to a Sharp Memory 96x96 pixel LCD screen using SPI.
Currently the code writes two numbers and a...
I've modified the ble_app_uart example by adding GPIOTE so that the transmitter sends a character to the receiver when a GPIO pin is toggled. This part is working well.
...
Hi,
I am working on my hardware product having nRF-51422 chipset. I just came to know from forum post that
nRF-52 chips will get arduino IDE support as standalone. I want...
Hi,
I'm on pre-product of BLE Advertisement packet scanner.
My product is gathering the adv packets from a bunch of BLE tag about 20~30 tags.
So, I use two nRF52832...
Hi,
I want to add bonding information manually.
1.can I assume IRK key will be constant for multiple peripherals?
2.if IRK only key is available, can i add it to peer...
I am finding that the voltage measurement is about .52 volts off when measuring Vdd I have set up a power supply and connected it to external power. My saadc is set up with...
Hi,
I am starting to finalize a development stage and was looking at the current consumption of my device. I noticed, that when something connects to it and is starting...
Hello there,
we get the following assert:
"00> <t: 480881>, app_error_weak.c, 98, Softdevice assert: 88996:0"
The board is rebooting constantly after 3 ... 7 minutes...
I tried to build the example project for UART serialization demo, "ble_app_hrs_pca10040_s132_uart". It failed with 3 errors, see attached image.
It is SDK 17 and SEGGER...
Product: nrf52840 DK
Softdevice: 17.0.2
Hello,
I would like to start with a very humble statement that I am new to this nrf52 SoCs and would appreciate any of your...
Hey everyone,
I am playing around with Nordic Cloud, Thingy:91 with the Asset Tracker v1 and the Nordic Cloud RestAPI.
I happened to see in the process, that the unix...
Hello,
I contact to you because a customer bought the development tool part number n RF52-DK, and one received the product, they noticed that there was on the box of the...
I use nRF52 DK as a central devices and i have also other nRF52 DK and use for a beacon. I would like to show my beacon's RSSI value on the UART Terminal(Realtek,Termite exc...
Hi,
I have done buttonless DFU in Custom board using NRF52832. My code with DFU is working fine in the nrf52832 Development kit. While I am trying in a custom board. My...
I'm developing for nRF52 DK
using SDK 17.02
Segger 5.10b
I'm developing a service to read pin 12 where I'll have a square wave signal of about 60Hz. When I tested my...
Hi,
Is there an example code for nRF52832 were the system is configured to operate in a certain duty cycle, e.g. performing a certain task once every 100ms, and then goes...
