Hello,
I have a device based on nRF51822 revision 2 and SoftDevice S110 v7.1.0. Because it is revision 2 it is affected by PAN44 and PAN45, and by default the SoftDevice...
Hi Guys,
I know this is more for software issues. But I was curious as to where I can find trusted case providers/makers for the nrf51822 Beacon. Can anyone from the community...
Hi,
Has anyone converted the Adafruit graphics library for Arduino, Adafruit_GFX.h, to be compatible with the nRF51?
Could you please advise on how to convert this Arduino...
Hi all,
I have a few questions:
How is that ADC's common mode rejection capabilities? Rejection for 60 Hz interference, etc...
The datasheet has "typical...
Hi all !
I'm trying to evaluate the throughput i can have between a Motorola 4G and the nrf51. The nRF51 is the peripheral and the phone is acting as a central.
To do...
I have a digital microphone chip, it has the CLK, DATA, LR_SEL three pins, now I will pick up the three pin nrf5283 three pin is as follows: CLK connectionI2S_CONFIG_SCK_PIN...
I want to increase the throughput as much as possible from the central to the peripheral, but when the number of consecutive calling bt_gatt_write_without_response_cb() or...
Hi,
We are evaluating the nRF52840 dongle. We need to dictate, have a conditional connect feature based on the BLE version. We should specify that use the BLE version...
Hello everyone,
I just wanted to post an important detail when using Nordic's DFU.
After the successful run of the Nordic's buttonless DFU example (by following this...
Hello All,
I am developing a product based on thread protocol.
I am using nRF52840 development kit and nRF5_SDK_for_Thread_and_Zigbee_v4.1.0_32ce5f8 SDK.
I am new to...
After upgrading segger to 5.42 we are now getting the following error when compiling the Bluetooth DFU bootloader part of our existing projects
section .uicr_bootloader_start_address...
Hello,
I am developing an application using
1. SEGGER Embedded Studio.
2. SDK 17.0.2.
3. Cortex-M nrf 52840.
Recently I changed the OS from FreeRTOS to embOS and...
Hello Devzone,
We update our peripheral device(nrf52) with our gateway(nrf52840, central) using the DFU protocol. We have this working and the DFU update is successful when...
Hello,
I am using CUSTOM service in nrf52 for BLE Communication.In the tutorial, there isn't any BLE READ event but I figured that BLE_GATTS_EVT_RW_AUTHORIZE_REQUEST event...
Is there any example for using the Watchdog with the BLE Mesh?
Experiencing some asserts, and would like to restart the device if it happens.
There is an example for the...
I am trying to use the mpsl_radio_notification_cfg_set() API function to configure a radio notification. However, calling the function returns -115, which is (NRF_EINPROGRESS...
Hi:
We are develop an Central Device can Connect 8 BLE Device in same time. and want max throughout. it use queue and freeRTOS. the Central TX is simple.
use sd_ble_gattc_write...
After successful compilation of code the west flash command shows this output after using Tag connect to debug the icarus board with the nrf9160 development board. Normally...
Hi. I know this issue already point out by some of the developers. But I don't get the right way to generate a hex file for my client.
I select the Release on the top right...
