I am trying to find out the part number of the antenna (I assume it is a PCB antenna) used in the nRF51 DK ( www.nordicsemi.com/.../nRF51-DK) . I found a lot of similar questions...
Hi.
I am using the NRF52 Development board, on Keil uVision, to implement a C program that uses Dynamic Structs. The Structs re-size themselves ( by increasing their capacity...
Hello,
I have an NRF51822 (redbealab ble nano) that I would like to use to count pulses in very low power mode.
Pulses are asynchronous
The rate of pulses can...
Hi
I'm attempting to read a PT-100 sensor value that is part of a voltage divider using a nRF52.
Both the reference resistor and the PT-100 is sampled while the voltage...
Hi
I have been searching the forums, but were not able to find an answer to my question.
I'm trying to sample 4 analog inputs on the nRF51-DK using the ADC hal. (SDK10...
Hi
I have been trying to get two NRF24L01 chips communicate with each other since a week now, without much success. All what I can find on the net is Arduino examples using...
Hi
I have done several projects with the nRF905. I know the device quite well. Normally I use the CD, AM and DR interrupt pins to determine the status of the device, my current...
Hello
I have an application running which boots up fine.
I've written a bootloader which boots up first, and then jumps into the application including softdevice.
So...
I am trying to implement a TCP server with TLS support. I have the following confusion-
Do we need to use mbedTLS API explicitly or is it internally handled by a zephyr...
Hi,
I am developing a simple application where I read some data from a sensor, and publish the data with MQTT. I want to use PSM to conserve battery life, and I am able...
Hello,
I am using a nrf5340DK to test the BLE Central sample of Zephyr.
As a BLE peripheral I am using a nrf52840 dongle. I have it configured via nrfconnect SDK - Bluetooth...
Hello,
I try to modify the lpcomp example from the Nordic SDK to trigger the sampling of the lpcomp manually. I have added the following code:
I use AIn3 (GPIO 5) as...
Hello,
I'm using Zephyr SDK. I have got BLE characteristic (my device is a peripheral) with following settings:
After successful write operation, I want to reply with...
Hi,
I'm trying to build the peripheral_lbs sample app for the nRF5340 using VS Code and I cannot get past the build configuration stage. Any assistance would be appreciated...
Hi.
I´m trying to install the application asset_tracker_v2 on my nRF9160DK ver 0.9.0 board.
I´m using VS code and during the build i got errors.
"too few arguments in...
Is there any good tutorial about the Android-BLE-Library Nordic library ?
I have only found the examples, but you need to dig in the code to learn how to use.
Greetings,
What are the settings to allow an nRF52811 to use CODED PHY with the NCS peripheral_hr_coded sample?
NCS v1.7.0
board = ubx_bmd360eval_nrf52811 (effectively...
Hi,
nordic tearm,im use nrf52840 develop a ble hid keyboard,my description of report like this :
my send api like this:
my consumer key like volume add and reduce...
Hello,
In the document about Release assistance indication %RAI. It says
In addition to using the %RAI command, the application must tell when the data connection is...
