In the nrf51 series reference manual section 12.1.9 it states that there is hardware protection that prevents write instructions from being executed and that there is more...
Hello, I have established the connection between two pca10001 boards, one as central and one as peripheral using multilink_central and multilink_peripheral. I have serial...
Hi,my friend,
Now,I use nrf905.Situation is as follows:
I use the NRF PCB circuit of data manual.Nrf905 work, often loss of data.
1.The Product host is to use the stick...
Hi,
I want to use the Blend Micro with more security. I want use a passkey for the Bluetooth connection. For example through the iOS Device.
Is it possible? Static passkey...
How do I receive multiple signals simultaneously at a single receiver (433MHz) with multiple transmitters ?
I am working on a polling system. This one is similar to the audience...
Hello,
I established a connection between my central and peripheral module. Now i want to write characteristic value on peripheral. I tried with sd_ble_gattc_write function...
I am using the NRF24l01 for my products and looking to buy in bulk(100-1000). Now I know where to buy the just the IC but antenna design is a hard point to break right now...
Dears,
I just connected my Thingy 91 to the nRF Cloud and get a message i should update to FOTA_V2.
Anyone has a manual or instruction on how to proceed with this?
I try to obtain from IMSI number for a GATT Characteristic. However, by using AT+CIMI it returns valid result only after network connection established.
Could you please...
Hello, I have been working with nfc libraries. In the below code you can see the my main function. In the Set up NFC part, nfc_t4t_setup(nfc_callback, NULL), nfc_t4t_ndef_rwpayload_set...
I'm playing the peripheral example hrs.
I find that when it received a enable notify(that is write cccd handle to 01 00) from the central, the code actually doesn't do anything...
Hi
I'm installing SDK1.5.0 in Toolchain Manager 3.6.1, but I've been stucked at this stage :Updating tinycbor repository for 3 hours.
I think something wrong here, thanks...
I am new to BLE and Nordic.
We are trying to develop with SEGGER + PCA10040.
Is there any way of debugging more than one set of PCA10040 "at the same time" on just one...
Hi ,
I have a project there wtih 2 devices , which is 1 slave and 1 master for Immediate alert service. the master will scan the slave for connection , but I don't know...
Hello.
After pairing with a tablet or computer, if you leave it for a few seconds without operating it
I wrote out the cause of the disconnection by debugging.
"Error...
refer to: https://infocenter.nordicsemi.com/index.jsp?topic=%2Fug_nrf91_dk%2FUG%2Fnrf91_DK%2Fboard_controller.html devzone.nordicsemi.com/.../problem-with-uart0-on-nrf9160dk...
