Hello,
I see when you import an example from the pack installer ( for example pwm, ble, timer examples ) it arrives with the misc controls --c99 on by default , so I cannot...
Hi,
We're looking for a low-latency 2.4GHz solution (not BLE) and the nRF51822 is oft-quoted as providing low latency, but what are the typical ms figures we could achieve...
Hello all,
in my previous question (Switch between applications (multiple services.h)) I got the advice to merge my two services into one service, including a HID over...
I am trying to create an nRF8001 based application that will broadcast battery levels (pipes broadcast, set), and give out temperature data (pipe indicate - TX_ACK) to connected...
Hi,
I'm using redbearlab's nrf51822 board. It is a arduino compatible board and hence it is using 0,1 (mapped to 9 and 11 for nrf51822). How do I make printf print to this...
An external PA/LNA is used to extend range of nRF51822, and S110 is used for BLE, How to switch between PA and LNA? and how to disable PA/LNA when there isn't transceiving...
Hi,
I was suddenly getting a EPERM error on nRF Connect for Desktop. I have uninstalled and re-installed. I get same error, plus Jlink now is showing a error at installation...
Hi,
We're developing a device based on the nrf52840.
We want to read LC3-encoded files on the filesystem, decode them, then send the data to the i2s peripheral. However...
I measure the quiescent current of Thingy:91X (v1.0.0) with enabled BLE connectivity bridge.
To my surprise, this seems to be significant larger than that of a Thingy:91...
Hi,
I have following problem:
I try to synchronize specific event let's say every three seconds. My simple test is just looping date_time_now() and taking modulus out...
I am attempting to create an SPI communication to an ancillary circuit through an intermediary board and the nRF52840 USB dongle. If I start with the zephyr sample spi_flash...
Hi, I am starting from the following example: "Bluetooth Low Energy UART service sample", sdk version v2.6.0 I am trying to add a custom board (using VSCode NRF CONNECT extension...
ncs v2.9.0
peripheral_uart (nRF52840) modified code
central_uart (nRF52832) unmodified code
using power monitor for current consumption
When I send the packet from...
I want to update some data stored in UICR CUSTOMER area on an nrf52832.
Code to do this works fine, as long as the areas are already erased (0xFFFFFFFF).
However, if they...
Hi,
I'm doing a test with a test harness. An error occurs in test case TC-CNET-4.16. I would like to know how to solve this problem.
environment
・TH raspberry pi 4 Version...
Hello everyone,
I am currently facing the issue that migrating to NCS 2.9.0 is not possible as I get the following compile error:
Someone else had the same issue: Unfortunately...
