Hi everyone,
I have found your git "Ble Optiboot"( github.com/.../ble-optiboot) , and I have understood, it is usefull to load a binary into MCU flash, I was looking for...
I'll go ahead and describe what I need to do and see if anyone might have some place to start for me since I'm having a lot of trouble figuring out what I need.
I'm looking...
Hello ,
I'm designing an embedded system with one of your RF chips (NRF24L01+) and as far as I searched for the datasheet , It seems like NRF24L01+ doesn't have a hardware...
Hi,
This post is very old.
devzone.nordicsemi.com/.../
I have a nrf51822 chip and I'm using it as BLE and it exposes some service and characteristics and it is working...
Hello!
I set up a project using NRF24L01 and a patch antenna ceramic, the type used in GPS.
In fact, I tested several types of antennas, F, F inverted, GPS, Loop. But...
Hello,
I'm trying to create a PC application to read out some Ti Sensor Tag modules. I'm using a nRF51822 USB dongle and the Master Emulator api.
The nRF dongle sees...
Hi
I have my code like this .
unsigned char *encryptedData;
unsigned int encryptedDataAfterAppendingLength;
memset(encryptedData, 0, encryptedDataAfterAppendingLength...
Hello, I am working on a project that is in charge of measuring temperature and sending values via BLE. I am working with the DS18B20 sensor and I have helped myself a lot...
Im trying to use lvgl with ST7789v display and nRF52832, in nRF Connect.
My .overlay:
My prj.conf:
When I enable LVGL and build, i got the error:
Could...
Hi,
I´m tryng to developer an application with nrf9161dk and i need create and upload a txt file with FTP. I´m in trouble to create the file with <zephyr/fs/fs.h> and...
Hi,
Your Dev Academy email-verification system may be broken, or I am broken :-)
After submitting the sign-up form, I am told to check my email to complete my registration...
Hi,
I tried the subsys/usb/console sample with nrf7002dk and I have ttyACM2. docs.nordicsemi.com/.../README.html
I copy the prj.conf to the end of the prj.conf of the...
Hello,
I am attempting to connect to a Wi-Fi network using Exercise 2 from Lesson 2 of the Wi-Fi training in Nordic Academy. However, when I try to connect to the network...
We are trying to configure our device, which is custom based on nrf7002dk for interface certificate testing. The requirements for testing are
Ensure correct Internet Header...
Hello,
Im trying to flash my dev board but im keep getting following error:
Error: One or more batch tasks failed: * 1057707318: [Probe] Emulator error: Failed executing...
Currently, in the early stage of code development with NCS 2.8.0, I'm getting some errors when configuring I2C (TWIM) for a sensor device in a custom board.
The overlay...
On the NRF7001 module there is a "Determine the trim value" section in the documentation. I have followed the "Receive-based approach" to determine the CALIB_XO value. This...
Hi,
I have several deployed devices that have been running for a while, using the nRF Cloud A-GNSS system with the nRF Location library. These devices were successfully...
hi I have recently been developing ncs on vs code. However, I encountered a strange problem. After I clicked build configuration, there was no output in the terminal, except...
Hello all,
I have this problem: when I add support for OTA my bonding information are canceled after power on. Without ota all is perfect.
Example: - Turn on the device;...
