Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
I'm using an nRF52832 with SDK v15.3.0 configured as an SPI slave in mode 0, with a master clock speed of 1.25 Mbps. My SPI pin assignments are:
- CS -> P0.06 - MISO ->...
I built an application and tested it with DK, and it worked well. I then created a custom PCB and attempted to flash the application, but the BLE part is failing with the...
Hello,
Platform: nRF54L15, SDK 2.9, VS Code
Our application is Matter + BLE (like NUS) based door lock application. A BLE custom service (adapted from NUS) is used to...
Hello,
I am currently learning Zephyr via the Developer Academy in preparation for an upcoming project that will use an nRF9151 and a Nordic BLE module. I will need to write...
Hi!
First of all, sorry but I will not be able to provide anything to re-create the bug... I did modify the code that may have made it happen in the first place quite a...
Hi, my two nRF52840 devices are set as peripheral and central respectively. Both devices use nRF52 SDK.
I try to update the PHY in the two devices, after they are connected...
Hi,
I was playing with my development software in VS Code everything was OK apart from the Cmake error message.
Once I had to restart my computer I couldn't build my...
Hello team,
We are developing a custom board on which eSIM is used for cellular connection. We will use Serial LTE modem application to control cellular modem through...
Hi,
I am using the nRF5340 Audio DK board with the nRF5340 Audio application under NCS v2.8.0 as a Unicast client.
I observed that changing the connection interval to...
Hey everyone,
We have been struggling to get our nRF7002DK connected to any HTTPS server. We've stripped back our evaluation setup to use "google.com" with the example ...
Hello,
I wanted to verify if two devices are communicating by using a sniffer.
After running the radio_test example, I set up parameters for each transmitter and receiver...
Hi,
I just reinstalled a fresh version of VS Code 1.96.2, and I'm using v2024.12.55 of the nRF Connect for VS Code extension. I'm also using nRF SDK v2.1.1.
In the past...
Hello,
Version - nrf Connect SDK v2.7.0
We have our own project which, I believe, has correctly configured signing using a custom key file.
In VSCode I've created a...
