Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hi, I'm new to BLE and just started feasibility testing, using RF8001, on a small device with no IO. The device will have a unique code set at factory, and printed on label...
I had the same experience as fishman and I went back to give Eclipse a try. (Post: nRF Beacon does not build on Android studio) I tried to build it in Eclipse Luna with the...
I want to get the value of battery voltage using pin number with battery voltage monitoring function in nRF52840. What I tried was to use the function "nrf_gpio_pin_read(...
Hi,
I am getting started with an example in this YouTube tutorial .
I downloaded SES and have gotten the NRF51SDKv12.3.0 from the Nordic Semi website ( here ).
I don...
Hello NRF ,
How Do I flash my dfu bootloader ( merged with softdevice ) and my application hex from nrfgo studio ?
I am able to flash merged bootloader from go studio...
I want to know how to configure parity, stop_bits, data_bits, flow_ctrl parameters in UART in the xx.overlay file.
Although these parameters can be configured through the...
Hi
Nordic Team
I use ncs1.6.0, SES compiler.I have a very difficult problem:
Now I am debugging the 2.4g communication between NRF52833 and NRF24LE1. I set the rate...
In the Provisioner example (unmodified) given in nRF5_SDK_for_Mesh v4.2.0, they provide only 2 elements, even and odd. I've got 3 or more servers and I would like to control...
I have developed two codes based on app_ble_uart for central and peripheral and added peer manager to it for link encryption. The peripheral device advertise based on SIG...
Hello
I am using the PCA10040 board to capture packets for 3rd party BLE4.2 device
I can see on wireshark all advertizing packets
my question is , can I also capture...
We are using nRF9160 and have a rare issue with a very high current consumption from the battery. We are using lithium-thionyl chloride 3,6V batteries, three in parallel....
Hi Everyone! I'm developing a program for NRF52820 that reads the tx power & rssi and makes the calculation for testing different devices, and I've faced some problems while...
Hello Nordic Semi team,
I am building two BLE product. One acts a peripheral and has server capability. Other is central with client capability.
I am trying to understand...
Currently we are integrating the serial and BLE DFU into a single binary executable. The project enables the logging (NRF_LOG_ENABLED = 1) and we use RTT as backend.
When...
i am using VS code, nrf Connect SDK version 1.7.0, (2) nrf 5340 DK boards. Running the CLI example.
uart:~$ ot diag start
failed
error 13 invalid state
uart:~$ ot...
I'm just starting to make a project using SDK 17.1, which is loosely based on a working, mature project based on SDK 15.2 and I'm hitting a bunch of issues. My path here is...
