Hi I've got my nRF8001 breakout board ready I now need the SDK in order to start developing firmware code.
I don't have any registration key, how do I get hold of it? ...
Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
We've tried to port IoT SDK features (IPv6 over Bluetooth low energy) to Nordic Thingy 52 .
As base, we use FW for Nordic Thingy 52 from GitHub
We need to send...
The last table on the S132 Specification BLE "data throughput" web page lists the maximum GATT Notification send/receive rates as 16kbps when using an event length of 2.5ms...
I've been following the instructions on how to test buttonless secure DFU without bonds using the Buttonless DFU Template Application page.
I followed the instructions...
I'm trying to port my project from SDK11 to SDK14.
I am having troubles understanding how the drivers supposed to be used.
In the files nrf_peripheralXXX_drv.c there is...
Hi guys,
has anyone had problems with: Cannot connect to J-Link via USB. message?
The device is alive and i can flash and connect to it from CLI.
Thanks
Hi guys,
Many thanks for the help before, I could now running example and change the parameters in the example code for my Taiyo Yuden nRF51 board.
Say, I would like...
Hello,
I don't know how to enable the notifications for a characteristic in the nRF Connect app for iOS. I have the latest version and I tried all the buttons but none...
Hi,
has anyone observed a behavior where the peripheral would be displayed as Accessory on iOS?
I'm seeing this occasionally with my S132 v5.0.0 peripheral, but can't...
In Android, is there any way to distinguish between an explicit disconnect requested by the remote device, and a disconnect due to loss of comms; eg, the remote device going...
Hi.
When I make flash bootloader_secure_ble, it does advertising well.
And I run DFU by making bootloader_secure_ble into .zip file.
However, it does not advertise bootloader_secure_ble...
Hallo,
I'm trying to create an application zip file to be uploaded with the DFU mechanism.
nrfutil pkg generate --help gives a list of options, but in the --sd-req part...
Hello,
I am using nrf52832 pca10040 with softdevice v3 of SDK v12.2, when booting my device tries to initialize the peer manager with pm_init() and this function is returning...
Hi All
I want to develop a PCB that has Wifi and BLE capabilities, to do this I would like to use Nordics: NRF51822 or the new NRF528, for the wifi side of things I want...
Hi all. I'm trying to use the u8g2 library with ss1306 controlled OLED display. After I added the library to the project, Keill gave an error
Error: L6406E: No space...
