Hi,
I have been using nRF51822 with my Android app using Android's Bluetooth Low-Energy APIs.
In order to get more details, I am currently working on integrating the Android...
I'm looking at interfacing a typical Wheatstone bridge sensor to the nRF51822 ADC. This particular sensor only requires a mA or two for excitation and the output fits within...
When use the "nRFBeacons" app to update the info on my beacon the following happens:
Go to update tab.
Select "Connect"
Press "SW2" on beacon and see the LED begin flashing...
I am using s110 and nrf51822. I've set up up a long characteristic of 154 bytes.
Sending between 1 and 154 bytes works as expected.
Sending 155 - 160 bytes gets rejected...
Hi,
I tested the nrf beacon application, it allows only the beacons with company identifier 0x0059 (nordic's id). But i need to modify it to support all the device, how...
I use a app_timer_create() function to create a task(200ms once)
when in the task_timeout_handle() ,
I do something more than 200ms,
what will this timer going ?
Hi!
I use nrf51-pwm-library ( github.com/.../) to control brightness of LED RGB light source and it works ok till I don't want to adjust brightness slowly (dimming function...
Hello Nordic support,
I have a requirement to develop a multiprotocol (BLE , ZigBee, Thread) application on nRF52840 and planning to use nRF Connect SDK for the development...
Shalom!
Using Window 10 Home, from nRF Connect v3.6.1, I installed the nRF Connect SDK v1.5.1. Previous I also tried to install it by the Getting Started assistant until...
Hello.
I am developing using nrf52832 (S132 v7.0.1, SDK v16.0.0).
During development, I was wondering if advertising and scanning could be done at the same time.
If...
I read several posts on devzone and figured out a workaround for errata 220. I am going to test this after applying it. But the test takes time. So, I would like to hear the...
I'm starting to look at using Ceedling (+Unity + CMock) for some test driven development but am having trouble getting tests that use/mock the SDK. I'm currently trying to...
Hi all. i just want to wake up or put into sleep my device once the user push a button for more than 3s. (the rest of the program works perfectly, also the timmer etc..) I...
Hi,
Kindly give solutions for this error! which needful for our projects, while writing the data on flash memory , written working as perfect, but if I write the data...
Hi.
I have some questions regarding the Heartbeat Example mentioned in this Ticket: Ble mesh heartbeat example - Nordic Q&A - Nordic DevZone - Nordic DevZone (nordicsemi...
sd_ble_gattc_characteristics_discover(conn_handle, handle_range); HI, here conn_handle what parameter need to pass and m_clientService declaration where you did?
Hello
I am using a Nrf52832 kit from Murata japan distributor.( https://wireless.murata.com/mbn52832.html)
My purpose is to be able to perform DTM on above mentioned kit...
Hello,
I am working with Window Covering cluster.
I receive command ZB_ZCL_WINDOW_COVERING_GO_TO_TILT_PERCENTAGE_CB_ID from my coordinator successfully, but I can...
Hello
I need to broadcast large amount of data on MQTT ~ 300K
I require to send it as fast as possible
how can I best calibrate settings for maximal speed send via...
i am using ble_app_uart example on nRF52833 board. I want to make a function that whenever I press button 1 on board, the board will disconnect Bluetooth connection with my...
