NCS currently has a nice feature where the firmware versions are printed in the boot banner:
Is there a config option to also enable printing the nRF91 modem firmware...
Dear all,
after cutting the SB bridge to the QSPI chip and close the ones to get the pin free and disabled also qspi inside the nRF52840dk_nrf52840.overlay file I'm unable...
Hey, I have a problem understanding BLE behavior
I had a product was running in BLE phy 1M, and I wanted to convert it into PHY CODED.
It just sniffs all the advertisement...
Dear all,
I stubled upon the following issue when developing a BLE sensor product. When I try to bt_gatt_notify(); With only one characteristic, there is not an issue...
I was looking into the sdk provided by nordic for nrd52840Dk board and want to test the zigbee protocol. I havn't find any sdk for that.
Can you share me some links and...
Hello Team,
I want to configure P2.07 as UART RX for my custom board.
But when I clear the already assigned property as led2 for this pins from the pin editor gui, I am...
Hi,
I am trying to adding a coded phy support on my device in NCS project.
once I added CONFIG_BT_CTLR_PHY_CODED =y in my config , the ROM size will add more than 7kB...
I installed nrfgostudio_win-64_1.15.1_installer, nrfgo_sdk_2.3.0_setup and nrfprobe_v2_0_0_7252 to test nRFgo starter kit(nRF6700). I tried to test uart on nRF24LE1D. but...
I want to establish a link between two nRF8001 devices. Is there an example of how to do it? I am using micro controller on our application board to control the nRF8001 devices...
Dear Developer Zone,
At this time, it is possible to upgrade the firmware version using Bootloader. But, is there any way or any plan to upgrade also the softdevice version...
Hi,
I'm looking for a wireless solution to handle 500-1000 of Clients per area. Because i',m new to Bluetooth i don't know if this is possible.
Requirements:
Network...
Hi,
I using the application download the update firmware, and using the bootloader erase and write the firmware to flash.
And I changed the bootloader code, remove all...
Dear Nordic Developer,
I am using nRF51822 with softdevice.
What is the best approach to have a nRF51822 always discoverable? Like heart monitor for example : no need...
If I receive data on the UART that comes in via its event handler, how can I then create an event to wake up from sd_app_event_wait and do further processing from the application...
400 control modules
I'm starting a project.
I need to reach a maximum of 200 meters.
I work with PIC. I'll have to control 400 MODULE Transceive.
Which model should...
Hi,
I have modified the ble_app_hrs source code with more no of custom characteristics(approximately 10), When i press Service Discovery in the master control panel, i am...
Hi ,
For our application i created 9 rtc1 timer .
all timers are working fine.
but once i stop battery timer and start it again ,it is giving receiver link loss....
Hi,
Actually In our application we have a battery, by external source we can charge it. Now when we connect battery or external power supply directly no error is coming....
