Hi,
Recently I want to set up a dynamic network that with the node change this position ,the network will change dynamically.But there is the question,with the node's position...
Dir Sir. I am checking the current profile of nRF24AP2 in RX mode.
After "open channel" command, I found the peak current at 10ms interval until connection pass.
How does...
Hello,
I am using Nordic's UART service to communicate with my project. I use iOS and also Master Control Panel (with a dongle) on a laptop.
I have two questions:
...
SWI*_IRQ is using by softdevice to send event to application, I want to know which priority does softdevice set for them?
Does sd_nvic_critical_region_enter() disable...
I am a started guy.
I only need a bluetooth device (BLE) to check the signal and mac address.
What is the best choice?
I need the smallest and low powered!
Thank you...
I am working on code to setup a bond manager for ancs based off of the example, but have a fixed advertising and connection interval of 25ms. How does the bond manager and...
Hello Guys,
can someone help me solve this problem (see picture below). Apparently Keil is missing an RTE and CMSIS component. I don't know where to get them. I installed...
Hi
I am trying to get to the bottom of a problem I am having with sending a buffer of data on connection and indication enable.
Here's what I do:
I have a process running...
Hello Everyone,
I am trying to use a display (through SPI) in a custom board with nRF51822 and SoftDevice S120. All works great as long as I call the SPI methods from main...
We have the HCI DFU working. The PC sends the new hex image (python script) via UART to nRF51822. Therefore, the bootloader code on the nRF51822 works. However, in the final...
Hi,
i'm using s130 central/peripheral. I want to send data from my central nrf51822 to my peripheral nrf51822.
I declare write function like this:
static void writeChar...
I'm fairly new to nRF51 development and have started looking at the soft devices. I've had a look over some examples, but I feel the code isn't always clear about what's required...
I am looking to migrate to SDK 8.1 and S110 V8.0 and going through all the implications of that move. One key one is the current Bug with Radio Notifications on S110 v8.0...
Hi everyone,
I am a new here~ If I asked some stupid question, please easy on me.
Currently I am doing a prototype with nRF51822 chip. I know that the official programming...
What is the purpose of the TWI overrun flag given that the TWI peripheral only supports master mode?
I have the following code in an ISR for my TWI acting as master.
...
Hi guys. I have a nRF51822 reference design board which is based on low voltage mode circuitry (using 1.8V supply directly). However, my Segger Jlink (SWD) does not work while...
By default, S110 advertises in all three advertisement channels. I need to limit the advertisement channels, so that I can advertise on a single.
In a similar question...
I now this are basics. And I did this allready a few times, but in this project it simply wont work.
Maybe someone of you will find something, that is missing.
I`m working...
Examples like the "proximity application" are all associated with the nRF51422_xxAC. The part I'm using is the nRF51822_xxAA. How do I make this examples work with my part...
