Hi,
I'm running Mac OS X 10.10.2 with the nRF51-DK PCA10028 card that I received today. I started off following the instructions in this article , and was able to get JLinkExe...
Hello,
I would like to do an communication between Arduino and Android platform.
In my case, Android will be master.
But I want also test between 2 Arduino with an Bluetooth...
Hello,
I would like to develop a custom key sharing algorithm for nRF8001 chips. As far as I have understood the only way to use full 128-bit temporary key (TK) is OOB...
i am useing nRF51822 pairing with nRF24lu1 over GZLL protocol now,
is there someone have the experience on how to config the parameter of GZP_TX_RX_TRANS_DELAY in function...
I have a peripheral running the S110 stack, which presents a characteristic to which I want the central (running S120) to be able to do a long write. What I've been trying...
Hi all,
I have been trying to combine the UART and hID Keyboard examples into a single application.
I want to use the HID part to send specific keystrokes using buttons...
Hello,
I am adding an extra characteristic (of 6 bytes) into one of the services that exist in the default beacon app. Then I try to update this characteristic using master...
Hello Guys,
can someone help me solve this problem (see picture below). Apparently Keil is missing an RTE and CMSIS component. I don't know where to get them. I installed...
Hi
I am trying to get to the bottom of a problem I am having with sending a buffer of data on connection and indication enable.
Here's what I do:
I have a process running...
Hello Everyone,
I am trying to use a display (through SPI) in a custom board with nRF51822 and SoftDevice S120. All works great as long as I call the SPI methods from main...
We have the HCI DFU working. The PC sends the new hex image (python script) via UART to nRF51822. Therefore, the bootloader code on the nRF51822 works. However, in the final...
Hi,
i'm using s130 central/peripheral. I want to send data from my central nrf51822 to my peripheral nrf51822.
I declare write function like this:
static void writeChar...
I'm fairly new to nRF51 development and have started looking at the soft devices. I've had a look over some examples, but I feel the code isn't always clear about what's required...
I am looking to migrate to SDK 8.1 and S110 V8.0 and going through all the implications of that move. One key one is the current Bug with Radio Notifications on S110 v8.0...
Hi everyone,
I am a new here~ If I asked some stupid question, please easy on me.
Currently I am doing a prototype with nRF51822 chip. I know that the official programming...
What is the purpose of the TWI overrun flag given that the TWI peripheral only supports master mode?
I have the following code in an ISR for my TWI acting as master.
...
Hi guys. I have a nRF51822 reference design board which is based on low voltage mode circuitry (using 1.8V supply directly). However, my Segger Jlink (SWD) does not work while...
By default, S110 advertises in all three advertisement channels. I need to limit the advertisement channels, so that I can advertise on a single.
In a similar question...
I now this are basics. And I did this allready a few times, but in this project it simply wont work.
Maybe someone of you will find something, that is missing.
I`m working...
