Hi,
I'm trying to program nRF51822 Beacon Kit using nRF51DK. I'm trying to load the example ble_app_beacon to the beacon kit. After uploading SoftDevice 7.1.0, I try to...
Hello
I'm using the nRF51 DK and I have a UART over BLE link set up between the board and a phone with the nRF UART app. I'm trying to get the board to execute a particular...
Hello there guys i been reading your 100 pg PDF for awhile now and im yet to understand or realize how is it that i add/place/create a payload or data to send/Tx via Master...
I am interested in writing a BLE central that reads data from multiple BLE Nordic sensors. The BLE central will be running on Embedded Linux which uses the BlueZ stack.
...
Hi,
I'm trying to get S110 softdevice (v8.0.0) working with RIOT. I had some issues (I couldn't initialize TIMER1 or TIMER2 until softdevice is setup & enabled) but I think...
Hello everyone,
I got a task which I try to implement using a NRF51822 iBeacon board.
The Task:
Advertise a Device and provide a mechanism to connect without traditional...
Hello, I'm working with the EK PCA10003, that has the NRF51422. I'm trying to read the information of the accelerometer MPU6000 with an ISP interface. At the moment I cannot...
Hi, I was wondering how to change from central mode of the NRF52 board to peripheral mode and from peripheral mode to central mode by pressing the input buttons on the board...
In the blinky-central example, on_ble_evt() switches over both BLE_GAP_EVT_DISCONNECTED and BLE_GATTC_EVT_TIMEOUT .
Why is this required? Won't a client GATT timeout...
Hi,
since the nrf52 offers the capability of NFC and BLE I am interested in methods a customer could use his smartphone for payment. Is there a common way or open standard...
Hi all,
I have programmed my chip nrf51822 successfully using stlink and the openocd. I have burned the same hex file which is there in the example that is the ble_app_uart...
Hi,
I've been trying to port my project from SDK10 to SDK12. I'd thought this would be a simple process. Definitely simplier then when I ported from SDK6.1 to SDK10. However...
I would like for the nodes in the network to be able to talk to any other node, even if the other node address are not pre-configured.
For example, I would like to be able...
Hi, Nordic
Now I have one nRF24LU1P USB Dongle, if sometimes there is no data in/out usb(maybe 3ms), USB Dongle will enter suspend state.
Can USB Dongle support to resume...
I am building the ble_app_hrs_freertos example code for a pca10040 dev board located in the SDK 12.2 at: nRF5_SDK_12.1.0_0d23e2a/examples/ble_peripheral/ble_app_hrs_freertos...
Hello guys,
I'm working in a project which requires from me to bond to certain devices and refuse the bonding from others, I mean at certain input, connect to anyone and...
Can I expect the call to sd_flash_erase() to successfully erase a page of flash while I have an ANT channel open doing a low priority search?
What about when doing a BLE...
Hi there,
Is it possible to use TWI0 and SPI0 (or TWI1/SPI1) time multiplexed?
When enabling them both in sdk_config.h I get "Error: L6200E... IRQHandler multiply defined...
