Hello,
I have a custom PCB with the nRF5340 chip. I’m able to flash the board using a J-Link. I’d like to rename the device so that it advertises a specific Bluetooth name...
Hello,*
I'm new to nRF Connect SDK environment, but I'm used to work with Zephyr.
I'm actually confused using west.yml file. I created a new application based on existing...
I made a custon pcb and until now it is working as expected . I am using the me54l14 module by minewsemi and i want to enable the CTE capabilities so that i can have angle...
Hello everyone,
I'm reaching out to this forum in a bit of a bind and hoping someone might be able to offer some guidance or assistance.
I'm trying to download the S340...
Hello,
We are currently using the nrf52840 for development using Zephyr v3.7.99-ncs1 .
We want to use the UART in low power mode and therefore, we have used the zephyr...
Greetings!
Briefly summarized: I am trying to generate SPDX files for our project, but I hit some roadblocks while running the west spdx command. I found a way to workaround...
We are implementing a Joiner device using OpenThread on the nRF5340 (with Zephyr, NCS v3.5.99-ncs1-4). After successfully joining the Commissioner's network ("Join success...
In the SDK, there are examples for boards called "pca10028, pca10040, pca10040e, pca10056"
I have the nRF52-DK board, which of the above numbers does it conform too? Or...
Hello,
I am trying to adjust a peripheral device to connect a central device based on ble_app_uart_c example. Although this example has been discussed numerous times I was...
I am moving an SDK12 peripheral nus + central nus application to SDK14.
I am following the ble_app_hrs_rscs_relay example for SDK14 on how to setup the dual role ble event...
The nRF52832 OPS 0.6.3 describes the CONFIGID register in FICR. This is the same as on the nRF51822.
SDK 14.1.0 does not show this register in the NRF_FICR_Type definition...
Hi everyone, I've read some nordic forum articles on this topic but somehow I just dont get information I need.
I can flash my custom nrf51822 chip by using my nrf51422...
Hi,
I'm currently evaluating the use of the nrf52832 as an HCI interface with a linux host and realized from the various questions that the nrf SDK does not support the...
I am running on Uvision. 5.23.
I am running a Central on one PCA10040 DK and a Peripheral on a second PAC10040 DK.
When I run a first RTT Viewer V6.22 (with SWD Target...
Below is from SDK14.2.0 ble_gap.h
There is no white list variable.
/**@brief GAP scanning parameters. */ typedef struct { uint8_t active : 1; /**< If 1, perform...
I am developing a general case application for several devices I am developing. The application template will then be modified in small ways to support different hardware...
Hello everybody, I try to send nus_string data. I bought different inputs and outputs like this;
INPUT;
OUTPUT;
"aaaaa" received // Send 5 times "a"
INPUT;...
Hi team,
I looking for an example on how I can setup a mesh to send and receive string of characters from and to mesh nodes.
I have couple of nrf52832 modules connected...
hello there i downloaded nordic's new mesh sdk. i am using nrf51dk. in mesh sdk there is no keil project . only source file is given. can you tell me how to make project using...
