Hi Nordic Team,
The atomic fifo implementation is based on armv7-M, right now I want to port it into cortex-A processor, I made some changes to get it compiled without...
Hi,
Kit:nrf5340
Can you please tell me if there is any example in nrf connect SDK v1.5.0 related to data transfer concepts.
Is ble controller will be enabled during...
I'm was testing the gsp sample in samples/nrf9160/gps. It runs fine on my nRF9160DK and reports NMEA messages. However, when i ran it on my custom board, it failed in setup_modem...
Hi,
I'm attempting to obtain sensor values for a project to be completed less than a week from now and I have not yet started programming so any help would be greatly appreciated...
Hi
I am using nrf52832,SDK version: SDK : RF5_SDK_17.0.2 .
USE CASE:We have two central and one peripheral.We need to control two central with one peripheral(REMOTE...
Hello,
I am facing an issue with SPI when the SoftDevice S132 is enabled and i cannot figure out what the problem is.
The following test works perfectly when SoftDevice...
Hi,
I would like to read a large data file from SD card and send over BLE from my device to an Android smartphone. I have adapted the ble_app_uart example into my program...
SDK: 15.3.0 SoftDevice: S132 Device: EYSHJNZWZ (nRF52832)
I am considering adding the following bootloader to my project. nRF5_SDK_15.3.0_59ac345\examples\dfu\secure_bootloader...
I'm trying to distinguish disconnect reasons for debugging purposes. I've been able to glean that
BLE_HCI_LOCAL_HOST_TERMINATED_CONNECTION means that my device initiated...
We use a gpio to control the system power. This gpio need to be kept high when system is running. If doing a soft reset, this gpio will be low. System will power off directly...
Hello,
I am having an issue with Zephyr, it constantly reboots the system because of stack overflow.
Sometimes in these faults, it says "Fault during interrupt handling...
I am trying to use RTC to get timestamp (to get current time). So, I am using FreeRTOS which uses RTC1 by default, libuarte which uses RTC2 and I am not using softdevice as...
I am trying to program my Thingy:53 with the Edge Impulse precompiled application firmware which I downloaded from the nordic website. The nrf Programmer Desktop app is showing...
Using NCS 1.7.0 with a an nRf9160/nRF52820 split Host/Controller as a peripheral and an nRF52840 as a central. I can connect to the peripheral with my central fine and write...
hello Nordic
i am working with ncs 1.7.1 (soon we are moving to zephyr 2.9)
i want to add a driver self test functionality for some of my drivers so in my application...
Hello We have been using the RSA example found in the nrf_cc310/rsa which uses INTEG_TEST_PRINT, a mask of SEGGER_RTT_printf, for debugging. When using NRF_LOG instead of...
Hi,
I have a working code that uses the UART FIFO instance which uses the app_uart_put and app_uart_get functions to communicate to an external LCD module. I want to now...
NCS 2.0.0
I start a timer using k_timer_start with a duration of multiple seconds (ive tried 10, 30, and 60) but the immediate next line of code (k_timer_status_sync) never...
Hello,
I'am working on a custom project with an nrf52832. Now I want to use the nrf52 to emulate an nfc tag. Regarding to the technical documentation, the nrf52832 supports...
Hello,
I am working on developing an application on the NRF5340 development kit which scans for nearby BLE beacons. I am using the Bluetooth RPC Stack for communication...
