nRF24l01+ at a transmitter module one time successful transmission show & after 1 sec failed also . if any doing programming with atmega32 ,please send code for TX & RX ....
Hello,
can the radio notification and radio disable APIs be used to use the radio hardware from the application layer?
Background of my question is, that I have an application...
Hi,
I am using central s120 with peripheral s110. The connection to the peripheral is depending on the name advertised by the peripheral.
When connection is done, the...
Hello,
I am trying to ecrypt some data in order to send some data encrypted in the MINOR and MAJOR adverts of the device.
I used this code to ecrypt the data ( this is...
Hi,
i use anRF51822 with soft device 7.
I run the UART app on my iPhone 4s with ios7 and on the nrf51822 board the ble_app_uart with keil uVision5.
Both devices connected...
Hello,
I upgraded nRFgo Studio software to version 1.17.0. Installation goes OK but the application crashes every time I try to launch it after installation process.. Then...
Hi,
i tried to send data from ios 7 via tx_characteristics(like in UART example) but received error:
didWriteValueForCharacteristic 2A38 error = Error Domain=CBErrorDomain...
(I know it has been asked before, but I thought I'd check in again..)
Has anyone had any success implementing the Dallas one-wire protocol on the NRF51822 - in particular...
Hello,
I imagine this is a pretty common and basic question but I couldn't find anything online.
Since the nRF52xxx chips are single-band 2.4GHz (and possibly sub-GHz...
I'm having trouble writing to a gatt characteristic using the python bindings for pc-ble-driver
Service discovery works fine, I managed to connect to a BLE server and reading...
I have a device that I need to control, that needs 2 different square wave signals of different frequencies (although they may be multiples of each other), one at around 4...
Hi all. I try to run capacitive sensor example on nRF52832 with my hand made capacitive sensor which I made according to this tutorial devzone.nordicsemi.com/.../.I connected...
Hello,
When i execute a function that uses TWI from a timer handler the NRF gets stuck.
I assumed that this issue occurs because of interrupt priority so i gave the TWI...
after connecting and disconnecting advertisment not stopping when i try to stop it ( sdk 11). Without establishing connection i am able to stop it. Nrf51822
Hello
I am trying to create secure connection between peripheral device and mobile app & central device.
I created my own custom service and want to make them secure...
Hello,
My goal at the moment is to be able to configure my peer device which utilize ble_app_uart example so it would connect only to a specific master device e.g. android...
I am using BLEPeripheral and MySensors libraries and nRF51822 device(client side).
I want to change functionality, if I press key of nRF51822 device it should start to advertise...
I have a PCA10040 working with the mesh sdk.v1.0.0 serial example. I can do an Echo via the Python interactive_syaci and get a back a response. I have seen the documentation...
Hi Nordic
I am running ble and ANT + bsc code on our custom board. However, since the sd_softdevice_enable function does not return, I asked the question once. devzone.nordicsemi...
hi i am using nrf52832 soc with sdk14.2.0 ble_central_multi-link example with soft-device s132v5.0
i want to know that is that any way to set connection handle number can...
